7
10. Reversing the door hang, (Fig. 7)
Lay the appliance on its back. Remove the 8 screws
(1). Remove the door, together with the two hinges
(2), from the housing.
Remove the two cover caps (3) from the housing and
place them in the open hinge holes in the housing.
Place the bottom righthand hinge in the top left of the
door and the top righthand hinge in the bottom left of
the door and hang the door on its hinges in the open
cover cap holes in the housing. Secure the hinges
and cover caps with the 8 screws.
Check that the door closes easily and is sealed
properly.
11. Replacing the decorative
door panel, (Fig. 8-10)
Remove the two screws (1) from the upper hinge of
the door.
Pull the door together with the hinge away from the
housing and up off the lower hinge bolt (2-3).
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two corners
are cut off by approx. 5 x 5mm (8). Put the frame edge
(5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the upper
hinge into the opening, press together with the
door against the housing and secure with the two
screws (11).
GB
Figure 7.
12. Customer service
Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does not
cool sufficiently
The appliance does not
cool at all
Possible cause
Thermostat control is set too low
Too much food to be cooled was put in
Door is not shut properly.
Refrigerator not level
Internal air circulation is restricted.
External air circulation is restricted.
CUC system stopped the operation
Plug is not connected to the mains
socket properly.
There is no voltage in the mains socket
Solution
Set to a higher position
Put in less food to be be cooled
Check if the door is shut
Level refrigerator
Provide inside cool air circulation.
Provide outside air circulation.
See operating instruction 5. 2.
Check if the connection is proper.
Check if there is voltage.
(eg. Connect a lamp to the socket)
Figure8.
Figure10.
Figure 9.
