6
GB
1. Unpacking
After removal from the cardboard packaging, make
sure the appliance is not damaged. If you find damage
to the appliance resulting from transport, report it
immediately to the transportation firm.
2. View of the appliance (Figure 1.)
1. Door
2. Door lock (if available)
3. Lamp
4. Evaporator cover
5. Evaporator sensor (behind evaporator)
6. Evaporator
7. Shelves
8. Air sensor
9. Foot
10. Door racks
IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC ZRT DO NOT ACCEPT
LIABILITY FOR LOSS OR DAMAGE OF KEYS. HOWEVER A COMPLETE LOCK CAN BE SUPPLIED.
3. Cleaning
Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these, parts,
as well as the cabinet interior and the door should be
washed with a warm solution of sodium bi-carbonate.
Finally wipe over with a cloth rinsed in warm water
only, and dry with a clean cloth. Do not wash any
plastic parts in water that is more than hand warm, and
do not expose them to dry heat. The outside of the
cabinet should be wiped down regularly with a clean,
damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE
CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF
COOLING
During the refrigeration process, the appliance
gives off heat from the condenser (under the
upper part of the rear cover) into the surrounding air.
The more ventilated the condenser is, the more
effective the refrigeration will be.
The other condition for satisfactory operation is that
the appliance is levelled. This could be checked by
placing a glass of water on top of the appliance.
It is important that the appliance is not directly
exposed to radiated heat (sunlight, radiator, near an
oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with an electrically
heated absorption cooling unit which is virtually
silent in operation. The fridge is designed for free-
standing installation, but can be built-in if the
following conditions are complied with to ensure
satisfactory operation and maximum cooling
efficiency.
4.1.1. Built-in version
This version is planned for building-in purposes.
The miniBar can be screwed to the furniture using
the fittings at the bottom. Drive in the screws (figure
2).
Difference between pivot points can be equalized
with the help of the sliding hinge, which is a
standard accessory for this version. The hinge
recommended to fix onto the top third of the
refrigerator's door. Please make sure before final
fixing that the flat sliding part allows normal door
opening in order to avoid door sticking (figure 2).
At the building-in process please take into
consideration the items listed below.
IMPORTANT
Please follow the installation details below
carefully. Guarantee is valid for products
installed as described only.
1. The refrigerator must be le
vel both
directions
2. There should be 20 mm clear
ance to the wall
3. Ventilation must be provided as shown in
alternatives A, B, C or D (fig. 3-4)
4. The ventilation duct must at least measure
105 mm x the width of the refrigerator
5. Only
the entire cooling unit must project into
the duct as shown
