684658
4
Zoom out
Zoom in
Previous page
1/6
Next page
3
When using electrical appliances, basic safety precautions should be
followed to reduce the risk of fire, electric shock, and injury to persons or
property. Read all instructions before using any appliance.
Do not operate thisor any other appliance with a damaged cord.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
This ice-maker must be positioned so that the plug is accessible .
Connect to properly polarized outlets only. No other appliance should
be plugged into the same outlet. Be sure that the plug is fully inserted
into the receptacle.
Do not run the power cord over carpeting or other heat insulators. Do
not cover the cord. Keep cord away from traffic areas, and do not
submerge in water.
We do not recommend the use of an extension cord, as it may
overheat and become a risk of fire. If you must use an extension cord,
use No. 14 AWG minimum size and rated no less than 16 Amps with
a plug.
Unplug the ice maker before cleaning or making any repairs or
servicing.
Exercise caution and use reasonable supervision when appliance is
used near children.
Place the ice-maker away from direct sunlight and make sure that
there is at least 5” of space between the back of your unit and wall.
Keep a minimum distance of 5” on each side of your unit free.
Do not use other liquids to make ice-cubes other than water.
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY TIPS
8
2. Plug your appliance into an exclusive, properly installed, grounding
wall outlet. Do not under any circumstances, damage or remove the
grounding prong of the plug. Any questions concerning power and/or
grounding should be directed toward a certified electrician.
3. This appliance requires a standard 115-120Volt, 60Hz electrical outlet
with three-prong ground.
Before using your ice maker, it is strongly recommended to clean it
thoroughly.
1. Remove the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Use clean water to rinse the inside parts under the top cover, and
drain out the water by unplugging the drain cap on front bottom.
4. The outside of the ice maker should be cleaned regularly with a mild
detergent solution and warm water.
5. Dry the exterior with a clean soft cloth.
6. When the machine is not to be used for a long time, drain water
completely.
This machine is not a freezer, therefore cannot store the mode
ice. To store ice and keep frozen, please transfer to a regular
freezer.
1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the MAXIMUM water level mark.
2. Plug in the ice maker. Press “ON/OFF” button on the control panel to
begin the ice making cycle.
3. Select the ice cube size by pressing the “SELECT” button. If the room
temperature is lower than 60°F, it is recommended to select small ice
cube in order to avoid ice sticking together.
USING YOUR ICE MAKER
CLEANING AND MAINTAINING YOUR ICE MAKER
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dometic HZB-12SA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dometic HZB-12SA in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info