323534
7
Zoom out
Zoom in
Previous page
1/36
Next page
-
7
-
Guide de mise en service
1. Installez votre table (voir page
11-13).
2. Sortez le réservoir de son
logement en le tirant vers vous.
3. Remplissez le réservoir d’eau au
maximum.
4. Retirez la cassette anticalcaire
de son sachet.
5. Ne retirez pas la mousse
filtrante.
6. Introduisez la cassette dans le
logement prévu dans le réservoir
d'eau, la partie en forme de
tube venant buter contre la
nervure du réservoir.
7. Tournez la cassette jusqu’à ce
qu’elle butte.
8. Replacez le réservoir en le
poussant bien au fond de son
logement.
9. Réglez le bouton du thermostat
du fer sur la plage vapeur.
10.Branchez l'appareil.
11.Appuyez sur le bouton
Marche/Arrêt pour mettre
l’appareil en Marche.
12.Le témoin de mise sous tension
s'allume. Le témoin de chauffe
du générateur s’allume.
13.Placez le variateur de vapeur au
milieu de la plage vapeur.
14.Attendez 30 secondes que
l’appareil soit prêt. Lorsque
l’appareil est prêt, il émet un
signal sonore d’alerte.
15.Appuyez sur la gâchette vapeur
jusqu'à obtention de la vapeur.
Lors de la première utilisation, la
vapeur peut être assez longue à
arriver. L’émission de vapeur
s’arrêtera en relâchant la
gâchette. Le bruit de la pompe
est normal.
16. Votre appareil est prêt pour le
repassage.
Quick Start - Anleitung
1. Stellen Sie den Bügeltisch auf
(Seiten11-14).
2. Den Wassertank herausziehen.
3. Füllen Sie den Behälter, bis die
Wasserstandsanzeige den
maximalen Stand erreicht.
4. Nehmen Sie die Kalkfilter-
Kartusche aus ihrer Feuchtigkeits-
Schutzhülle.
5. Filterschwamm nicht entfernen.
6. Kalkfilter -Kartusche in das
vorgesehene Gehäuse
einsetzen, wobei das
rohrförmige Teil gegen die Rippe
des Tanks gerichtet ist.
7. Dann die Kartusche bis zum
Anschlag drehen.
8. Den Wassertank wieder fest in
sein Gehäuse drücken.
Kartusche mind. 15 Min.
wässern lassen!
9. Den Thermostat-Regler zum
Dampfbügeln zwischen
●● und
●●● stellen.
10.Schließen Sie das Gerät an.
11.Schalten Sie mit dem Knopf
“Ein/Aus” das Gerät ein.
12.Die Kontrolllampe “Unter
Spannung” leuchtet auf. Die
Kontrolllampe “Vorheizen des
Generators” leuchtet auf.
13.Stellen Sie den Dampfmengen-
regler auf die Mitte der
Dampfskala.
14.Warten Sie 30 Sekunden, bis
das Gerät betriebsbereit ist.
Wenn es soweit ist, ertönt ein
Tonsignal.
15.Dampfstoßtaste drücken, bis Sie
Dampf erhalten. Bei erster
Inbetriebnahme dauert es bis zu
30 Sekunden, bis Dampf
erzeugt wird. Während des
Betriebs ist das Surren der
Pumpe normal.
16.Ihr Gerät ist jetzt betriebsbereit.
Quick Start guide
1. Setting up the table (see page
11-14).
2. Remove the water reservoir from
its housing by pulling it towards
you.
3. Fill the reservoir to the maximum
level.
4. Remove the anti-scale cartridge
from the bag.
5. Do not remove the filter foam.
6. Insert the cartridge as shown,
lining up the tube with the mark
on the reservoir.
7. Turn the cartridge to the right as
far as it will go.
8. Replace the reservoir by pushing
it right into its housing.
9. Set the iron thermostat dial
between the 2 and 3 dot
settings.
10.Plug in the appliance.
11.Press the On/Off button to
switch the appliance on. The
power light indicates that the
machine is switched on.
12.The power on and generator
heating pilot lights.
13.You should turn the steam output
dial to the middle setting.
14.Wait 30 seconds before the
trying to use the iron. At that
point you will hear an audible
signal.
15.Press the steam trigger until
steam is released. After refilling
or fitting a new cartridge, it may
take up to 30 seconds before
you can call for steam. To stop
steaming, release the steam
trigger. The pump can be heard
humming during normal use.
16.Your product is ready for
ironing.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Domena cr 3 ecofibres at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Domena cr 3 ecofibres in the language / languages: English, German, French as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info