!"#$%LI
2. Repeatedly press the «INCREASE»
or «DECREASE» keys to display the
3$/()$3%*(-$9
3. If the «TIMER» key is not pressed for
a few seconds, the time display will
disappear and be replaced by the disP
play of the ambient temperature. The
timer is then activated.
4. At the end of the time set, the device
x(..%/*26%"0*2-"*(1"..D9
DEFROSTING FUNCTION
The device is equipped with an automaP
*(1%3$5)2/*(+#%0+(*9
When the room temperature is low, the
device’s evaporator may freeze.
A. In cooling or dehumidication mode,
if the device detects that the evapoP
rator temperature is ≤ -1°C, defrosP
*(+#% *"K$/% 6."1$% "0*2-"*(1"..D4% "+3%
the POWER indicator ashes. During
defrosting, the compressor stops for
about 10 minutes. As soon as the
temperature is > +7°C, the device
)$/*")*/9
B. In dehumidication mode, if the deP
vice detects that the temperature of
the evaporator is < +40°C and that,
"5*$)% "66)2;(-"*$.D% &\% -(+0*$/% 25%
operation, the difference between
the temperature of the compressor
and the temperature of the room is
kjHF]M4%3$5)2/*(+#%*"K$/%6."1$%"0*2P
matically for about 5 minutes, and the
POWER indicator ashes.
%%
COMPRESSOR SAFETY
To increase the life of the compressor,
during a start-up or restart, there must
be a 3-minute delay before the comP
6)$//2)%/*")*/9
%
DRAINAGE
This device is equipped with an autoP
matic evaporation mechanism. This
mechanism makes it possible to cool
the condenser and therefore improve
the cooling capacity, and also allows for
)$301$3%62x$)%12+/0-6*(2+9
It is not necessary to empty the water
tank in cooling mode unless humidity is
very high. However, in dehumidication
-23$4%(*%(/%(-6$)"*(,$%*2%12++$1*%"%3)"(P
nage hose to the permanent drainage
20*.$*9
Automatic drainage
In cooling and dehumidication modes,
it is possible to install a drainage hose
(not supplied) so that water is contiP
+020/.D%$,"10"*$39
1) Have a suitable hose available. It
must be connectable to the permaP
nent drainage outlet found in the
middle and lower down at the back of
the device.
2) Unscrew the cap from the permanent
drainage outlet and remove the stopP
6$)9
3) Connect the hose (not supplied) to
the outlet and connect the other end
to a wastewater outlet. Make sure the
hose is tilted slightly downwards and
is not pinched.
NOTE: Do not immerse the end of the
hose; the air contained in it may prevent
the ow of water. It is recommended
that the hose should be at least 20 deP
grees from the horizontal.
