!"#$%L\
INSTALLATION OF THE OUTLET PIPE
1. If it is not already assembled, t the
connector (2) onto the outlet pipe (1).
%
2. Fit the other end of the pipe into the
adapter (3).
%
3. Fit the connection (2) of
the outlet pipe (1) to the
hot air outlet of the air
12+3(*(2+$)9
%
4. Install the adapter (3) into the winP
dow kit, then the window kit into the
rail of your sliding window. When the
window is closed, it must be as tight
as possible. If necessary, shutters
should be added in order to avoid
energy loss (consult dealer if necesP
sary)
5. Adjust the length of the outlet pipe:
%%%%%%%%%%%%%
- The outlet pipe must be held paralP
.$.% "+3% -0/*% +2*% A$% A$+*% 2)% 3()$1*$3%
downwards: the air must be able to
ow freely through the pipe.
- Do not extend the outlet pipe to a
length of more than 400 mm. Even if
the pipe supplied is extendable, do not
attempt to lengthen it excessively. Do
not replace it with a longer pipe: the
length between the device and the
extractor must be as short as possible.
- This device is suitable for a surface
")$"%25%"66)2;(-"*$.D%I\%-b9
- Make sure that the hot air outlet pipe
"3"6*$)%(/%6)26$).D%/$*%06%"112)3(+#%*2%
your type of window. Do not twist the
6(6$%$;1$//(,$.D9
