507616
29
Zoom out
Zoom in
Previous page
1/64
Next page
29
Electrode gap
The electrode gap must be .020" (0.5 mm).
Checking the ignition spark
- Press the loosened spark plug with the ignition cable firmly
connected against the cylinder using insulated pliers (not
near the spark plug opening).
- ON/OFF switch in the "I" (ON) position.
- Pull the starter cable hard.
If the function is correct, an ignition spark must be visible near
the electrodes.
Cleaning the air filter
A
B
- Remove the filter cover (A/1) (2 screws).
CAUTION:
Pull the choke (A/2) to shut the choke valve and to prevent dirt
particles from entering the carburetor.
- Pull the air filter (A/3) off the carburetor.
- Cover the carburetor with a clean cloth.
- Grasp the top and bottom sections of the air filter as
shown in figure B and pull apart.
CAUTION: To prevent injury to the eyes, do NOT blow out
dirt particles! Do not use fuel to clean the air filter.
- Clean the air filter with a soft brush.
- If the filter is very dirty, clean it in lukewarm water with
dishwashing detergent.
- Let the air filter dry completely.
- Put the top and bottom sections back together.
- Before re-installing the air filter, check the choke valve for
dirt particles. If there are any, remove them with a brush.
If the filter is very dirty, clean it frequently (several times a day),
because only a clean air filter provides full engine power.
Important: For sawing dry wood and working on dusty ground
we recommend using a Robkoflok air filter. The Robkoflok
filter keeps out even the smallest dust particles.
CAUTION: Replace damaged air filters immediately.
Pieces of cloth or large dirt particles can destroy the
engine!
C
Replacing the spark plug
STOP
1
2
3
1
D
.020" (0.5 mm)
CAUTION:
Do not touch the spark plug or plug cap if the engine is
running (high voltage).
Switch off the engine before starting any maintenance
work.
A hot engine can cause burns. Wear protective gloves!
The spark plug must be replaced in case of damage to the
insulator, electrode erosion (burn) or if the electrodes are very
dirty or oily.
- Remove the filter cover (see "Cleaning the air filter" above,
Fig. A/1).
- Pull the plug cap (C/1) off the spark plug. Use only the
combination wrench supplied with the saw to remove the
spark plug.
CAUTION: Use only the following spark plugs:
NGK BPMR 6F or CHAMPION RDJ-7Y.
STOP
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar PS-340 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar PS-340 in the language / languages: English, French as an attachment in your email.

The manual is 6,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dolmar PS-340

Dolmar PS-340 User Manual - German - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info