507651

Dolmar PB-252.4 Manual

15
Zoom out
Zoom in
Previous page
1/35
Next page
15
2. Cleaning of air cleaner
Interval of Cleaning and Inspection: Daily (every 10 operating
hours)
(1) Remove the air cleaner cover-fixing bolts.
(2) Pull the cover lower side and detach the air cleaner cover.
(3) Turn the choke lever to the full close side, and keep the carbu-
retor off from dust or dirt.
(4) If oil adheres to the element (sponge), squeeze it firmly.
(5) For heavy contamination:
• Remove the element (sponge), immerse it in warm water or
in water-diluted mild detergent, and dry it completely.
• Clean the element (felt) with gasoline, and dry it completely.
(6) Before attaching the element, be sure to dry it completely.
Insufficient drying of the element may lead to difficult startup.
(7) Wipe out with waste cloth, oil adhering around the air cleaner
cover and plate breather.
(8) Immediately after cleaning is finished, attach the air cleaner
cover and tighten it with fixing bolts. (In remounting, first place
the upper claw, and then the lower claw.)
3. Checking the spark plug
(1) Opening/closing the plug cover
When opening the cover, apply fingers to the main handle
and plug cover projection (Figure 1). Push up the projection
and slide the cover in the “OPEN” direction (Figure 2).
When closing the cover, slide the cover in the “CLOSE”
direction till the click under the plug cover projection rides
over the engine cover. Finally, push in the projection.
(2) Removing the spark plug
Use an attached box wrench to remove or install the spark
plug (Figure 3).
(3) Checking the spark plug
The clearance between two electrodes of spark plug is 0.7
to 0.8 mm (Figure 4). Adjust to the correct clearance when it
is too wide or too narrow.
Clean thoroughly or replace the spark plug if it has accumu-
lated carbon or contaminated.
(4) Replacing the spark plug
For replacement, use NGK-CMR6A.
WARNING: INFLAMMABLES STRICTLY PROHIBITED
DANGER
• Clean the element several times a day, if excessive dust adheres to it.
• If operation continues with the element remaining not cleared of oil, oil in the air cleaner may fall outside, resulting in oil contamination.
Plate
Element
(sponge)
Air cleaner
cover
Breather Part
Element
(felt)
Fixing bolt
Pick this part and remove the
element (felt).
Figure 1
Figure 3
Lateral electrode (–)
Figure 2
Figure 4
Electrode clearance
0.7 - 0.8 mm
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar PB-252.4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar PB-252.4 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info