507693
5
Zoom out
Zoom in
Previous page
1/31
Next page
5
Starting up the Hedge Trimmer
- Please make sure that there are no children or other people within a working
range of 15 meters (5), also pay attention to any animals in the working vicinity.
- Before operating, always check that the Hedge Trimmer is safe for operation:
- Check the security of the throttle lever. The throttle lever should be checked for
smooth and easy action. Check for proper functioning of the throttle lever lock.
Check for clean and dry handles and test the function of the I-O Switch. Keep
handles free of oil and fuel.
Start the Hedge Trimmer only in accordance with the instructions.
Do not use any other methods for starting the engine (6)!
- Use the Hedge Trimmer only for applications specied.
- Start the Hedge Trimmer engine only after the entire assembly is done. Operation
of the Hedge Trimmer is permitted only after all the appropriate accessories are
attached!
- Before starting, make sure that the cutter blade will not contact any objects such
as branches, stones, etc.
- The engine is to be stopped immediately if there are any engine problems.
- When working with the Hedge Trimmer, keep both hands on handles always
wrap your ngers tightly around the handle, keeping the control handle cradled
between your thumb and forenger. Keep your hand in this position to have your
machine under control at all times. Make sure your control handle is in good
condition and free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing.
- Only use outdoors.
- Always be aware of your surroundings and stay alert for possible hazards that
you may not hear due to the noise of the machine.
- Operate the Hedge Trimmer in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (risk of suffocation and
gas poisoning). Carbon monoxide is an odorless gas. Always ensure there is
adequate ventilation.
- Stop the engine when resting and when leaving the Hedge Trimmer unattended.
Place it in a safe location to prevent danger to others, setting re to combustible
materials or damage to the machine.
- Never lay down the hot Hedge Trimmer onto dry grass or onto any combustible
materials.
- To reduce re hazard keep engine and silencer free of debris, leaves, or
excessive lubricant;
- Never operate the engine with a faulty exhaust mufer.
- Stop the engine during transport (7).
- Stop the engine or disconnect from mains before:
- Cleaning or when cleaning a blockage;
- Checking, maintenance or working on the machine.
- Position the Hedge Trimmer safely during car or truck transportation to avoid fuel
leakage.
- When transporting the Hedge Trimmer ensure that the fuel tank is completely
empty to avoid fuel leakage.
- When transporting or storing the machine always t the cutting device guard.
Refuelling
- Stop the engine before refuelling (7), keep well away from open ame (8) and do
not smoke.
- Do not attempt to refuel a hot or a running engine.
- Avoid skin contact with petroleum products. Do not inhale fuel vapor. Always
wear protective gloves during refuelling. Change and clean protective clothing at
regular intervals.
- Take care not to spill either fuel or oil in order to prevent soil contamination
(environmental protection). Clean the Hedge Trimmer immediately after fuel has
been spilt. Allow wet cloths to dry before disposing in proper, covered container to
prevent spontaneous combustion.
- Avoid any fuel contact with your clothing. Change your clothing immediately if fuel
has been spilled on it (danger hazard).
- Inspect the fuel cap at regular intervals making sure that it stays securely fastened.
- Carefully tighten the fuel tank cap. Change locations to start the engine (at least 3
meters away from the place of refuelling) (9).
- Never refuel in closed rooms. Fuel vapors accumulate at ground level (risk of
explosions).
- Only transport and store fuel in approved containers. Make sure stored fuel is not
accessible to children.
- When mixing gasoline with two-stroke engine oil, use only gasoline which
contains no ethanol or methanol (types of alcohol).
This will help to prevent damage to fuel lines and other engine parts.
15 meters
(50 feet)
360°
(5)
(6)
(7)
• Resting
• Transporting
• Refuelling
• Maintenance
• Tool Replacement
(8)
(9)
3 meters
(10 feet)
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar HT-2475 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar HT-2475 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info