507717
13
Zoom out
Zoom in
Previous page
1/24
Next page
13
than 2 m away from the equipment. Failure to do this
may cause removal of warning/caution labels, above-
mentioned-electrical part damage and flood into the
gearbox casing resulting in damage to mechanical
parts, such as gears, bearings and the like.
Follow warnings, cautions and instructions stated in
labels and instruction manual of the power washer for
proper use. Failure to do this may cause a personal
injury and failure, damage or breakage to the
equipment.
If the battery ports or the area around them should be
splashed with water or flooded during cleaning, wipe it
off with a rag immediately.
3. Check all nuts, bolts, knobs, screws, fasteners etc. for
tightness.
4. Inspect moving parts for damage, breakage, and
wear. Have repairs made on any damaged or missing
parts.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by DOLMAR Authorized Service Centers,
always using DOLMAR replacement parts.
TROUBLE SHOOTING
012848
OPTIONAL ACCESSORIES
CAUTION:
These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
Dolmar genuine battery and charger
Holder
NOTE:
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Noise
ENG905-1
The typical A-weighted noise level determined according
to 2000/14/EC:
Sound pressure level (L
pA
): 70 dB (A) or less
Uncertainty (K): 2.5 dB (A)
The noise level under working may exceed 80 dB (A)
Wear ear protection.
Problem Possible cause Remedy
Neither the battery lamp nor the
warning lamp lights up even after
pressing the main switch.
Battery cartridge is not installed. Install the battery carridge.
Lock key is not inserted. Insert the lock key.
Malfunction of the main switch. Ask your local Dolmar Service Center.
With either one battery of the two
battery lamps lighted up, the
warning lamp light up after pressing
the main switch.
Battery is low. Lock key is pulled out. Charge the
battery.
Battery is not inserted properly. Remove the battery, and insert it again
carefully.
Malfunction of battery lamp or warning
lamp.
Ask your local Dolmar Service Center.
The cultivator blade does not rotate
even pulling the switch lever.
The main switch is not pressed. Press the main switch.
The lock-off button was not pressed. Keep pressing the lock-off button when
you pull switch lever.
The lock key is not inserted. Insert the lock key.
Malfunction of the switches. Ask your local Dolmar Service Center.
The warning lamp and the battery
lamp light up during operation.
Battery is low. Charge the battery.
The tool stops
suddenly. And the
warning lamp lights up
or is blinking.
light up The blade digs too deep, and the motor
is over loaded.
Change the depth of cultivation
shallower.
blinking An obstacle gets stuck on the blade. Turn off the tool by pressing the main
switch. Then remove the obstacle
carefully.
The blade does not stop. Switch lever is broken. Turn off the main switch.
Remove the battery cartridge.
Ask your local Dolmar Service Center
immediately.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dolmar AK3622 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dolmar AK3622 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 1,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info