766080
8
Zoom out
Zoom in
Previous page
1/27
Next page
8
Description
1 - Contact points 2 - Strap 3 - Target 4 - LED indicator
Battery insertion and replacement
Unscrew the 4 screws of the top of the receiver using a cross-head
screwdriver and remove the lid. Insert the 3V lithium CR2 battery into
the battery compartment. Please check that the battery is installed
with correct polarity (according to the polarity marks inside the battery
compartment - see the picture). Wrong polarity may damage the unit.
Approximately after a second, the receiver will beep if the battery is
inserted correctly. Before putting the lid of the
receiver back in place, make sure that the rubber
seal is correctly seated in its groove. Lubricating
the seal with a thin layer of silicone grease will
increase it‘s lifespan.
Screw down the 4 screws of the top tightly (do
not over tighten them).
1
3
2
4
Battery polarity marks
Receiver settings
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-fence 6th Sense at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-fence 6th Sense in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info