766075

Dogtrace d-control professional 2000 Manual

16
Zoom out
Zoom in
Previous page
1/20
Next page
16
Troubleshooting
1 Read again this user guide and make sure the problem is not caused by a at
battery or incorrect use.
2. Make sure the batteries are inserted with the correct polarity.
3. If the transmitter does not communicate with the receiver, try to program
communication - see chapter: Programming (pairing) the transmitter with the
receiver.
4. If it seems, that the dog does not respond to the stimulation impulse:
■ Check again the battery in the transmitter and in the receiver.
■ Test the receiver‘s functions with a test discharge lamp (see 5th paragraph of this
chapter).
■ Check whether you have choosen correct length of the contact points (see
chapter: Choosing the contact points) and ensure contact points are well
tightened and in contact with your dog‘s skin (see chapter: Fitting the collar).
■ If the dog has dry skin, moisten the skin.
5. Check the correct function of the stimulation impulse.
By using test discharge lamp you can easily check correct function of the momen-
tary / continuous stimulation impulse.
■ Make sure that the receiver is turned OFF.
■ Place the test discharge lamp in contact
with each of the contact points - loosen the
contact points, insert the lamp‘s outlets
under (the contact points so they are in the
touch with the screw and tighten them (see
picture).
■ Turn on the transmitter and the receiver.
■ Select momentary or continuous stimulation for any function button.
■ The test discharge lamp will increase a light intensity when increasing
stimulation level.
Using training collar in winter
When using d-control in winter, please keep in mind:
■ Low humidity – causes less skin conductivity. It is necessary to provide better
conductivity between the contact points of the receiver and the dog‘s skin. This
can be achieved by lubricating the dog’s skin in the touching points of the contact
points with vaseline, baby oil, hand lotion, etc.
■ Thicker fur dog – it is necessary to tighten the collar so that the permanent
contact with the dog‘s skin is ensured. If the fur is too thick, it is recommended to
cut the hair or choose a longer type of contact points.
■ Battery features change – temperatures below 0 °C slow down chemical
reactions in batteries. To ensure a performance of repetitive stimulation impulses
(especially of higher levels), it is recommended to insert a new battery into
the receiver for the winter time. During the training, observe continuously dog‘s
reactions and increase the stimulation level as needed.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control professional 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control professional 2000 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info