766072

Dogtrace d-control professional 1000 mini Manual

9
Zoom out
Zoom in
Previous page
1/20
Next page
9
3. Command setting – by pressing down button you can choose a command
for the selected function button A1 / A2 / B1/ B2. Selected command will be sent to
the receiver collar.
You can select following commands:
■ long discontinuous stimulation impulse
■ momentary stimulation impulse
■ vibration
■ light
■ audible beep tone
4. Mode and stimulation level setting – use buttons for impulse intensity
setting or for mode setting.
Receiver preparation
Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and
remove the lid.
2. Insert the lithium CR2 3V battery into the battery compartment with a correct
polarity (according to the polarity indicated with the “+” symbol in the battery
compartment – see the Fig.). A wrong polarity may damage the unit.
When you insert the battery for the first time, or if the battery is removed longer than
a few tens of minutes (approximately 20 minutes), you will hear an audible beep
tone indicating the correct installation of the battery.
3. Make sure that the rubber seal is clean
and correctly seated in its groove. Clean
any dirt from the seal.
4. Put the battery cover of the receiver
back and screw in the 4 screws adequa-
tely.
Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver.
(see chapter : Product description – Receiver)
The batterry is fully charged – when switched on, green LED is ashing.
The battery is low – when switched on, red LED is ashing.
When the battery is low or at, insert a new CR2 3V lithium battery into the receiver.
Note: When you replace the battery
quickly, you may not hear the audible
beep tone of the collar.
Battery polarity indicator
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control professional 1000 mini at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control professional 1000 mini in the language / languages: English as an attachment in your email.

The manual is 1,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info