766061
12
Zoom out
Zoom in
Previous page
1/19
Next page
12
Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint using the same transmitter or another (see
the section Programming (pairing) of the transmitter and the receiver).
Fitting the collar
The strap with the receiver (receiver collar) must be tightened enough so that the contact points are in
contact with the skin of the dog. We recommend you to t the collar on the standing dog. When you can
t two ngers between the collar and your dog‘s neck, the collar with the receiver are tightened enough.
If a dog has long or thick hair, it is suitable to trim the hair in the area of the contact points or to switch
to the longer contact points to ensure a consistent contact.
TIP: It is possible to program an unlimited number of receivers to a one transmitter.
Example: Button is paired with 3 receivers, they can be programmed one by one or we can set all
3 in pairing regime and then press button for audible beep tone. All these receivers will perform the
same action at the same time when pressing function button. This can be used for two collars on the
neck of one dog, or for the training of higher number of dogs, where we give the same commands to
all of them at the same time.
WARNING: If the collar is too loose, the receiver is likely to move and the repeating friction can
irritate the skin of your dog. Furthermore, in this case is not ensured a reliable contact of contact
points with the skin and a proper function of the training collar. We do not recommend to leave
the collar positioned at the same place for more than several hours, because it could irritate the
skin. If it is necessary to wear the collar for long periods, change regularly the position on the neck
of your dog. A collar with a receiver that is overly tight, can cause pressure sores on the skin in the
contact area of the contact points. If this happens, do not use the training collar until all traces of
irritation are gone.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 440 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 440 in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info