Manual Dogtrace d-control 400 (page 19 of 23) (English)

766056

Zoom out

Zoom in

1/23

It is important to keep the device clean. Never use volatile substances eg.: thinner, gasoline or other

cleaners. To clean your d-control use a soft, damp cloth and neutral detergent if necessary.

The receiver (collar) is water proof only on condition of the good state of the seal. We recommend

you to replace the rubber seal, which is placed under the cover of the battery compartment of the

receiver, once a year. Clean the rubber seal and make sure that the rubber seal is correctly seated in its

groove every time you change the batteries; tighten the screws using adequate power.

If the device is not used for a longer time, take out the batteries from the battery compartment.

 Make sure that the receiver is turned OFF.

 Place the test discharge lamp in contact with each of the contact points - loosen the contact points,

insert the lamp‘s outlets under the contact points so they are in the touch with the screw and tighten

them (see picture).

 Turn ON the transmitter and the receiver.

 Select stimulation function button.

 The test discharge lamp will increase a light intensity when

increasing stimulation level.

6. If the problem still persists, contact the dealer.

Maintenance

Note: When is the level set to 00 there is no stimulation.

When you use test discharge lamp the stimulation impulse

is weaker than without discharge lamp.

Picture showing test lamp attachment

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 400 in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dogtrace d-control 400 Manual

Product: