766051

Dogtrace d-control 1640 Manual

9
Zoom out
Zoom in
Previous page
1/19
Next page
9
Programming (matching) of the remote controller and the receiver
Every remote controller has its own RF operational code. Programming of the remote controller
with the receiver (collar) will be accomplished during the rst use of the Dogtrace d–control
set or with a new remote controller or a receiver (when one or the other is lost). This operation
will enable you to match your remote controller to the delivered receiver (collar).
Turn on your transmitter.
Select dog 1 on the remote controller.
Touch the lower part of your remote controller to the target on your receiver (see the photo
on page 8). The green LED will be permanently lit and after some 3 seconds, it will switch to
the programming mode, indicated by ashing of the red and green LED at the same time.
Now take your transmitter away and press down the sound signal button on your
remote controller. The codes will be matched in this step and your receiver will produce
a sound signal.
Proceed in the same way when programming the second receiver (for the second collar for
d–control 642, 1042, 1642 models).
REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint either using the same remote
controller or with another (see the section Programming /matching/ of your remote controller
and receiver).
IMPORTANT: Before programming is started (before the rst use of your receiver or
code rewriting) make sure that no one else uses his/her d-control or another product
made by Dogtrace in your neighbourhood – your receiver could randomly receive the
code from the other remote controller and set itself to it. If this happens, program
your receiver once again using your remote controller.
ADVICE: It is possible to program an unlimited number of receivers to one transmitter,
which is possible to use for training of several dogs at the same time. It is possible to
record two transmitters into one receiver, which can be used, for instance, for
a potential correction of the dog’s training by an instructor.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 1640 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 1640 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info