766051
6
Zoom out
Zoom in
Previous page
1/19
Next page
6
Battery installation and replacement
INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)
Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver.
Install the 3V lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB
with “+“ symbol in the battery compartment (see photo).
A beep indicating correct installation of battery will sound.
If you do not hear the beep after installation of the battery, remove it immediately. Check
the polarity and try again.
Before putting the plate cover to its place make sure that the rubber seal is correctly seated
in its slot. Tighten the 4 screws on the cover plate of the receiver.
CAUTION: Always switch o the receiver before battery removal, remove the battery and
shortcut battery contacts using a metal tool (screwdriver, a pair of scissors and similar).
Checking the battery status
Look at the indicator on the front panel of the receiver (collar) to check the battery status:
The battery is fully charged: The LED indicator in on-state blinks slowly in green.
The battery is weak: The LED indicator in on-state blinks
in red. Prepare a spare 3V lithium battery CR2 and follow
the section describing the battery installation.
Make sure that the receiver works correctly.
Battery polarity mark
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control 1640 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control 1640 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info