67943
11
Zoom out
Zoom in
Previous page
1/12
Next page
Specifications
We follow a policy of continuous advancement in
development.
For this reason all or part of specifications & designs
may be changed without prior notice.
11
DLS CLASSIC RA25 RA30
Number of channels 2 3
Working mode AB AB
Power output at 13,8 Volt, 20 Hz - 20 kHz, max 0,1 % THD, all channels driven.
Power output, 4 ohm 2 x 70 W 2 x 70 W + 1 x 265 W
Power output, 2 ohm 2 x 110 W 2 x 100 W + 1 x 365 W
Power output, 4 ohm bridged 1 x 220 W -
THD @1 W < 0,1% < 0,1%
Signal to noise ratio, A-weighted >100 dB >100 dB
Damping factor >200 >200
Frequency response +/- 0,5 dB 10 Hz - 50 kHz 10 Hz - 50 kHz
Input impedance, low level >10 kohm >10 kohm
Input impedance, high level 330 ohm 330 ohm
High level input with auto start Yes Yes
Input sensitivity 0,2 - 7V 0,2 - 7V
Filter slope 12 dB/octave 12 dB/octave
Pre amp configuration on Front channel:
Filter high pass 20 - 150 Hz* 45 - 125 Hz*
* can be switched in/out
Pre amp configuration onRA30 sub channel:
Filter lowpass - 40 - 125 Hz
Fixed 25 Hz subsonic filter - Yes*
Phase shift 0- 180 degrees contiously - Yes
Grand bass adjustable gain @ 40 Hz - 0 - +18 dB
Remote bass level and phase control - Yes
* can be switched in/out
Protection current & thermal current & thermal
Max cable size, DC input 7 AWG, 10 mm
2
4 AWG, 21 mm
2
Max cable size, front speakers 7 AWG, 10 mm
2
10 AWG, 6 mm
2
Max cable size, sub output 7 AWG, 10 mm
2
Power consumption:
Idle 0,6 A 0,9 A
Maximum 25 A 70 A
Fuse 25 A 2 x 35 A
Dimensions HxWxD(mm) 59x247x245 59x385x245
Dimensions (inch) 2,33x9,72x9,65 2,33x15,15x9,65
Weight 2,6 kg (5,7 lbs) 4,4 kg (9,7 lbs)
RA25 & RA30
NOTE!
The amplifiers are two (2) ohm stable. In stereo
mode it´s possible to load the amplifier down to two
ohm on each channel.
In mono bridge mode it´s possible to load with one
four ohm fullrange speaker or subwoofer.
The sub channel on RA30 can handle 2 ohm loads,
for example two 4 ohm subwoofers in parallel.
In bridge mode connection an amplifier sees a four
ohm speaker as a two ohm load.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS RA 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS RA 30 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info