67778
7
Zoom out
Zoom in
Previous page
1/12
Next page
CAD11
Bridging two CAD11
Remote bass
level control.
To Remote on
head unit
GROUND
Battery
Fuse
Distribution
block
Power Cap
You can connect two CAD11 in
bridge mode.
One of the amplifiers is ”Master”
that controls the signal to the
second amplifier that should be
used in ”Slave” position. The sig-
nal is fed through the Data link
cable. Connect the amplifiers as
in the drawing below.
Master slave selector & Data link
connection
Data
Link
Speaker
impedance:
4 ohm/2 ohm
From low level
output of head unit
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged switch:
Slave position
Bridged switch:
Master position
Connection of DC-input (to both amplifiers) and Remote sub level
control (to Master amplifier).
7
Connecting two CAD11 in bridge mode will
double the output power. Minimum speaker
load is then 2 ohms. The RCA signal must be
connected only to the amplifer set to run as
”Master”. The filters as well as the level control
is only working on the ”Master” amplifier.
Bridging two amplifiers can be done only
between amplifiers of the same model
Output power in bridge mode with
two CAD11:
4 ohm load: 1500 watts
2 ohm load: 2000 Watts
1 ohm load: Do not use!!!
Modular 4-pole cable to connect
between Data Link sockets
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS CAD 15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS CAD 15 in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info