163227
12
Zoom out
Zoom in
Previous page
1/16
Next page
CA51
Speaker wiring CA 51
Four fullrange speakers to CA51. One pair in
front and one pair in rear.
Rear speakers Front speakers
Filter settings A/B Channels
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 60 – 80 Hz.
The LPF-filter switch should be in OFF-position
Multiply
x1 x10
80/800Hz
Off On
200/2(k)Hz
50/500Hz
500/5(k)Hz
LPF
HPF
50/500Hz 220/2(k)Hz
15/150Hz
500/5(k)Hz
Off On
Multiply
x1 x10
HPF
Off On
50Hz 220Hz
15Hz
500Hz
Filter settings C/D Channels
LPF
Off On
80Hz 200Hz
50Hz
500Hz
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 25 – 40 Hz.
The LPF-filter switch should be in OFF-position
Subwoofer to CA51
The CA51 is a five channel amplifier. On channels
A/B, C/D the filter configuration is exactly the same
as for CA41. For speaker connections on these
channels you can use the examples for CA41.
Channel E is a subwoofer mono channel with a
lowpass filter adjustable from 50 to 500 Hz. Channel
E has also a subsonic filter that can be switched
IN-OUT. The subsonic filter has a fixed frequency
of 25 Hz.
You can connect one 4 ohm subwoofer to channel
E.
Filter settings E Channel
The subsonic filter takes away the very deepest
frequencies. Turn on the subsonic filter if you want
to remove these frequencis.
The LPF will allow low frequencies only and blocks
higher frequencies. A typical setting is 70 – 100 Hz.
The phase control can be set continuously from 0 -
180 degrees. This is very useful when you want to
adjust the bass sound for best front stage image.
Start on 0 and turn the control slowly clockwise until
you experience the bass sound coming from the
front. If you dont get
the result you want,
also try to phase reverse
the subwoofer
connections and make
a new adjustment.
12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS ca23 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS ca23 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info