163877
18
Zoom out
Zoom in
Previous page
1/26
Next page
DLS A6 is 1 ohm stable. This means that you can
connect four 4 ohm subwoofers in parallel without
damaging the amplifier. If you have a 4 ohm sub
with dual voice coils you can connect the coils in
parallel, one coil to each amplifier output.
NOTE!
The speaker output terminals are internally
connected in parallel. This is a mono amplifier
so it is not able to connect the outputs in bridge
mode. The double terminals are only for easier
connection of more than one subwoofer.
DC - FEED DLS A6
Fuse
150 A
Power
capacitor
Fan12 V
FUSES
35 A x 2
35
35
35
35
FUSES
35 A x 2
+
Battery
12 volt
To remote
on stereo / CD
POWER IN
BAT+ REM GND
POWER IN /POWER CAP
GND FAN OUT POS+
PROTECT
POWER
Phase LP-filter LEVEL
SPEAKERS
+ - + -
3,5V
7,0V 0,2V
SIGNAL INPUT
LEFT RIGHT
FM1 107,3
Subwoofer
4 ohm
Subwoofer
4 ohm
OUT
IN
90
50 125
+90
0 +180
OUT
IN
Sub Remote Bass
sonic Level
Connection of two 4 ohm
subwoofers
You can use all DLS subwoofers in this example.
All speakers must be 2-4 ohm. If you have
subwoofer with dual voice coils, connect one
voice coil to each output terminal. For power
cable, speaker cable and fuse size selection we
refer to page 2.
PHASE SHIFT CONTROL
The Phase shift control is variable from 0 to
+180 degrees. With this control you can fine
tune your subwoofers so they play in phase with
the rest of your system.
This feature is extremely useful when fine tuning
the different speakers and amplifiers of a SPL
competition vehicle.
REMOTE BASS LEVEL & PHASE SHIFT
A remote bass level & phase shift control is
included. This allows you to adjust the bass level
and phase shift from the front seat of your car.
Connect it to the socket marked Remote Bass
Level. When using a remote level control you
must activate it by pushing the switch on the left
side of the socket, to IN-position.
Button in
Subsonicfilter setting: IN (fixed 25 Hz)
LP-filter setting: 60-80 Hz
Remote Bass
Level & Phase
control
WIRING EXAMPLES A6
Phase
Level
DLS A6 has a built-in fan for cooling. The fan is
mounted in the bottom plate of the amplifier.
To get the best performance and cooling, mount the
amplifier on spacings. Doing so the fan can get fresh
air for best possible cooling.
The amplifier becomes very hot, especially when
loaded down to 1 ohm. When using 1,33 and 1 ohm
loads we recommend the use of external cooling fans
as well.
ULTIMATE A6
18
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS a7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS a7 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info