167594
10
Zoom out
Zoom in
Previous page
1/26
Next page
On the following pages you find some examples of how to connect the amplifier for different use. The
drawings show normal level and filter settings.
Remote
Pre out
DLS A2 can be connected in different ways:
1. As a stereo amplifier connected with a speaker system of coaxial, 2-way or 3-way type.
Two speaker systems can be connected in parallel, one front and one rear system.
2. As a subwoofer amplifier with max two 4 ohm subwoofers in mono bridge mode. The built-in lowpass
crossover is used. (Connect to L+ and R-).
DLS A2 has an inbuilt adjustable lowpass filter that should be set to approx. 60-80 Hz.
1. One speaker pair
connected in stereo
You can use all DLS coaxial, 2-way
or 3-way systems in this example.
The speaker impedance must be 4
ohm.
For power cable, speaker cable and fuse
size selection we refer to page 4.
+
+
-
-
FM1 107,3
Fuse
60 A
Battery
12 volt
+
DLS A2
HP-filter LP-filter LEVEL
7,0V 0,2V
3,5V
OUT
20
200
100
Hz
IN
OUT
50
125
90
Hz
IN
Highpass filter
not in use.
Lowpass filter
not in use.
If you have problems with the
mid bass driver ”reaching the
bottom” (the voice coil
touches the bottom pole
plate) at high volumes, use
the HP-filter to avoid this with
a setting at 50 - 80 Hz or
higher. Make your own tests.
Both
buttons
in out
position
Use a 2 mm hexagon key to speaker terminals.
Use a 4 mm hexagon key to DC input terminals on
Wiring examples DLS A2
ULTIMATE A2
10
3,5V
7,0V 0,2V
HP-filter LP-filter LEVEL
100
20 200
OUT
IN
90
50 125
OUT
IN
SIGNAL INPUT
LEFT RIGHT
SPEAKERS
+LEFT- +RIGHT-
FUSE
30
POWER
PROTECT
POWER IN
BATT+ REMOTE GND
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DLS a5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DLS a5 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info