594203
9
Zoom out
Zoom in
Previous page
1/31
Next page
©2013-2014 DJI Innovations. All Rights Reserved. 9 |
Increasing movement of the command stick will result in a larger
tilt angle (maximum is 35˚) and faster flight velocity.
The roll stick controls the aircraft left & right tilt.
Push the stick left and the aircraft will tilt and fly left. Push the
stick right and the aircraft will tilt and fly right. The aircraft will
keep level and straight if the stick is centered.
Increasing movement of the command stick will result in a larger
tilt angle (maximum is 35˚) and faster flight velocity.
GPS ATTI. ATTI.
(Manual mode or Failsafe is
selectable in the Assistant
Software.)
3-position switch (S1) on the Transmitter for mode control. Only
after Compass Module connection and Compass calibration, GPS
Mode is available. Otherwise, all switch positions are ATTI. Mode.
Pay attention because the GPS Mode is dependent on the number
of GPS satellites acquired by the main controller. When the GPS
signal has been lost for 3s, the system enters ATTI. Mode
automatically. You can enable the Manual Mode or Failsafe (also
known as One-key Go-home) in the Assistant Software ->Basic
->R/C ->Control Mode.
OFF Course Lock Home Lock
3-position switch (S2) on the Transmitter for Intelligent
Orientation Control (IOC). Set the switch to OFF in basic flight.
This function is defaulted to off. If you want to use this function,
enable it in the Assistant Software. Use IOC when you are
familiar with basic flight.
FCCCE
The compliance version can be reconfigured by twisting the
potentiometer knob on the back of the transmitter using a flathead
screwdriver. For CE compliance, set the transmitter to CE
compliance by carefully turning the potentiometer knob to the full
counter clock-wise position. For FCC compliance, set the
transmitter to FCC compliance by carefully turning the
potentiometer knob to the full clock-wise position. Users should
follow their local regulations accordingly.
You can change the operation mode of the Transmitter according to the PHANTOM RC Assistant Software
Description section if necessary.
Link between the Transmitter and Receiver
There is a 5.8G receiver in the PHANTOM FC40, with the link button and indicator located in the battery compartment.
The link between the transmitter and aircraft is already established for you so you can initially skip this procedure. If you
ever replace the transmitter, re-establishing the link is required.
Link Procedures
1.
2.
Power off transmitter and power on aircraft. You will see the link indicator blinking red.
Press link button and hold until the link indicator blinks yellow. Release the link button.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DJI Phantom FC40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DJI Phantom FC40 in the language / languages: English as an attachment in your email.

The manual is 4,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DJI Phantom FC40

DJI Phantom FC40 User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info