1. Install the DJI GO App
mobile phone.
2. Prepare the Battery
time. Insert the battery as shown.
and Android 4.3 (or later).
Charge Time: ~110 minutes.
complete.
Unfold the arms
Adjust the pads
Place one end
Place the other end
Pull outwards
Rotate to desired angle
●
SmoothTrack Mode is enabled automatically to
smooth out jerky movements.
●
The Osmo+ will beep slowly if the gimbal is locked
after it is turned on. This means the camera is
working normally but the gimbal is shut off.
●
If you need to unlock the gimbal after it is turned on,
you must rotate the pan motor after unlocking the tilt
motor and pan motor to reactivate the gimbal.
For more information, read the User Manual:
http://www.dji.com/product/osmo-plus
6. Controls
※This content is subject to change without prior notice.
Designed by DJI. Printed in China
●
Position the camera
directly by hand.
●
Use the joystick to pan or tilt
the camera.
●
Record Button
Press once to start recording, and
again to stop recording.
●
Shutter Button
Press once to take a photo. Press
and hold for burst capture.
3
1
2
4. Unlock the Gimbal
1. Rotate the tilt motor
5. Connect to the DJI GO App
2. Slide the Pan Axis Lock up
Activate the Osmo+ when using it for the first time.
This requires an internet connection.
Internet
Launch the app and tap Camera.
DJI GO
App
Turn on your mobile's WiFi and
connect to OSMO_XXXXXX
Default password: 12341234
OSMO_XXXXXX
To Power On:
Pull down on the switch
Pull down again > Sleep
Pull down and hold for 1.5 s > Power Off
2
1
●
Trigger
Hold down the trigger and push
the joystick up and down to
zoom.
Hold down to enable Lock Mode.
Tap twice to center the camera.
Tap three times to enter Selfie
Mode.
OSMO
TM
is a trademark of DJI.
Copyright © 2016 DJI All Rights Reserved.
www.dji.com
