Operating Temperature 14° to 104° F (-10° to 40° C)
Max Charging Power 180 W
7
.1
6 in
6
.
77
in
4.14 in
2.80 in
FCC ID： SS3-WM6101410 FCC ID： SS3-GL6581502
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
●
Calibrating the Compass
Ensure the compass is calibrated before every flight. Failure to do so may lead to unexpected flight behavior.
●
DO NOT attempt to calibrate your compass where there is a chance of strong magnetic interference, including areas near
massive metal objects, parking lots, underground steel reinforcements or under bridges.
●
DO NOT carry ferromagnetic materials, such as keys and mobile phones, with you during compass calibration.
●
The compass should always be calibrated when moving from indoor spaces to outdoor spaces.
●
After successful calibration, the compass may become abnormal when you place the aircraft on the ground. This may be
because of underground magnetic interference. Move the aircraft to another location and try again.
Always
fly under
400 ft
1
7
.7
6
i
n
12.44 in
17.24 in
●
The aircraft will not avoid obstacles while it is returning to the Home Point, and an appropriate RTH altitude must be set before takeoff. You
should also use the control sticks to guide the aircraft. Refer to the Safety Guidelines and Disclaimer for more details.
●
Positioning Systems (P-Mode)
The aircraft uses GPS and a Vision Positioning System (VPS)
to pinpoint its position and stabilize flight. It is strongly
advised to fly in P-Mode which, depending on the GPS
signal and aircraft altitude, has one of the following states:
P-GPS: GPS and VPS are used for positioning. The aircraft
can return home.
P-OPTI: Only VPS is used for positioning (< 9.8 feet). The
aircraft cannot return home.
P-ATTI: GPS and VPS are not available. The aircraft can
maintain balance but will drift from side to side. It cannot
return home.
The effective altitude for the Vision Positioning System is
below 9.8 feet. The Vision Positioning System will not work
properly over surfaces that do not have pattern variations,
over water or in low light conditions (< 100 lux).
Toggle the flight mode switch on the remote controller
to ‘P’ and wait for a stable satellite count before takeoff.
●
Return-to-Home
It is important to take off with a strong GPS signal
(green bars) to ensure that the Home Point is
recorded by the aircraft. The aircraft will
automatically return to the Home Point in the
following cases.
Smart RTH: The pilot presses the RTH button.
Low Battery RTH: The battery level is low or
critically low.
Failsafe RTH: Remote controller signal is lost.
DO NOT FLY in rain, snow, fog, and wind
speeds exceeding 22 mph or 10 m/s.
It is important to understand basic
flight guidelines for the safety of
both you and those around you.
Refer to the Safety Guidelines and
Disclaimer for more information.
DO NOT FLY near or above people, near
trees, power lines or buildings.
Learn more:
http://flysafe.dji.com/no-fly
No Fly Zones
DO MONITOR YOUR ALTITUDE
and fly under 400 feet
(120 meters).
DO MAINTAIN LINE OF SIGHT
and avoid flying behind buildings
or obstacles that block your view.
DJI encourages you to enjoy flying in a safe, responsible and smart way.
●
Be very careful when flying 14,700 feet (4,500 meters) or more above sea level as the battery and aircraft performance may be reduced.
●
The Inspire 1 Pro’s compass and GPS will not work in Polar Regions. The aircraft will auto switch to ATTI Mode and use the VPS for positioning.
Vision Positioning
Effective Altitude:
≤ 9.8 feet
GPS Positioning
INSPIRE 1
PRO
11. Gimbal Dial
12. Camera Settings Dial
13. Record Button
14. Flight Mode Switch
15. Shutter Button
16. Playback Button
17. Mini HDMI Port
18. Micro USB Port
19. CAN Bus Port
20. USB Port
21. C1 Button
22. C2 Button
10
4
9
8
5
6
1
3
7
2
21
171819
20
11
14
13
12
1615
The Inspire 1 Pro features the Zenmuse X5 gimbal and camera equipped with a 15mm f/1.7 (35mm format equivalent
30mm) Micro Four Thirds interchangeable lens. It shoots sharp 16MP stills and stable video at up to 4K. The aircraft’s
retractable landing gear pulls up out of view, giving the camera an unobstructed 360 degree view of the world below.
Through the DJI GO app, the camera focus, shutter speed, aperture and ISO can be manually adjusted. The DJI Focus,
a wireless follow focus system, can be linked to the remote controller of the Inspire 1 Pro for seamless and tactile camera
control across the entire flight range.
An advanced flight controller makes the Inspire 1 Pro stable, safe and easy to fly indoors or out. The revolutionary Vision
Positioning System (VPS) gives it the power to hover in position at low altitudes even without GPS. Like all DJI flight
controllers, it is also able to return home if remote controller signal is lost or if the low battery warning is triggered.
The Inspire 1 Pro boasts a maximum flight speed 18m/s* and a maximum flight time of 15 minutes* using one fully charged
4500 mAh Intelligent Flight Battery.
The maximum transmission distance of the Inspire 1 Pro remote controller is 16,400 feet (5 km)*. The built-in LiPo battery
powers the device for up to four hours in between charges.
An ergonomic design puts photo and video capturing, playback and gimbal control functions within comfortable reach,
crucial when the aircraft is being operated. Important controls such as raising and lowering the landing gear and activating
the Return-to-Home procedure can also be triggered with a tap of a button.
The Lightbridge HD video downlink is integrated into the remote controller, allowing real-time camera footage to be
displayed in the DJI GO app. Dual remote controller mode makes it possible for the aircraft and camera to be operated
on two separate controls, which have a communication range of up to 50 meters.
1. Power Button
2. Transformation Switch
3. Return-to-Home (RTH) Button
4. Control Sticks
5. Status LED
6. Battery Level LEDs
7. Power Port
8. Mobile Device Holder
9. Antennas
10. Handle Bar
* The maximum flight speed and maximum run-time (hovering state) were tested in a lab environment, at zero-level elevation and in windless conditions, and
should be taken as reference only.
* The maximum transmission distance was tested in a lab environment, and will vary greatly depending on your immediate area.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for DJI INSPIRE 1 PRO at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of DJI INSPIRE 1 PRO in the language / languages: English as an attachment in your email.
The manual is 13,73 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
