653258
2
Zoom out
Zoom in
Previous page
1/2
Next page
DJI FOCUS
Turn the focus wheel to control the focus,
zoom or iris of your camera lens.
Screw on the antenna.
1. Loosen the knob on the quick-release mount
and slide the motor onto the support rod.
Insert the neck strap connector
while pulling on the button.
Mount the lens gear ring if you are not
using a cinema lens with gear rings.
1. Choose the lens gear ring that best fits
your camera lens.
2. Tighten the screw.
Install the Antenna
Mount the Motor Calibrate the Motor
Used with the Zenmuse X5
Basic Operation
Attach the Neck Strap
Mount the Lens Gear Ring
Ensure the neck strap is attached securely.
Ensure that the lens gear ring and camera lens
make good contact.
Ensure the lens gear ring screw is installed
properly to allow an unobstructed full range of
motion.
Ensure the motor is mounted firmly.
DO NOT touch the motor when it is rotating.
Cable mode will take precedence over wireless mode.
The motor will automatically reserve a 1mm margin at both mechanical limits for protection.
The motor gear can be mounted on either side of the
motor. To remove the gear, loosen the knob at the
center of the gear.
The motor supports a 15 mm rod diameter by default.
To mount it on a 19 mm rod, slide the step-down
adapters off the clamp.
Ensure that the Zenmuse X5 camera is set in AF mode.
The remote controller overrides the in-app controls. You will not be able to adjust the focus or aperture in the DJI GO app.
You can purchase the dedicated CAN Bus cable on the DJI Store.
Turn on the remote controller by holding down the
power button for 2 seconds.
If your camera lens has mechanical limits, use Auto
calibration. Otherwise, use Manual-Remote or
Manual-Hand calibration.
DJI Focus is fully compatible with the Zenmuse X5 series gimbal and camera. To allow communication
between the two devices, connect the communication port on the Focus remote controller to the
CAN Bus port on the Inspire 1 remote controller using the dedicated CAN Bus cable.
Refer to the user manual for more information.
http://www.dji.com/product/focus
2. Tighten the knob, ensuring that the motor gear
and lens gear ring make good contact.
3. Connect the communication port on the motor
to an external power source using the supplied
power cable. If you are using the Ronin-M,
connect the motor to the P-TAP Accessory
power port on the Ronin-M.
50.0%
Calibrate Menu
To mount the motor onto your camera support rod:
Motor Power Cable
Auto
Select Calibrate > Auto (Shortcut: Press the ‘A’ and
‘B’ buttons together). The motor gear will rotate in
both directions in turn to locate the mechanical
limits of your camera lens. When the calibration is
complete, select Back to apply the calibration or
Stop to cancel.
Manual-Remote
Select Calibrate > Manual-Remote > Start to
begin. Press the up arrow to rotate the lens in one
direction, and select OK when it reaches the desired
upper limit. Next, press the down arrow to rotate
the lens in the other direction, and select OK when it
reaches the desired lower limit.
Quick Start Guide
DJI Focus can work in wireless mode or cable mode. To
use cable mode, connect the communication ports on
the remote controller and motor using the data cable.
Select Menu > Aperture > On to enable the Aperture Control.
To switch from focus control to aperture control, press the ‘D’ button and then follow the instructions in
the DJI GO app to operate the focus wheel.
1
2
Manual-Hand
Select Calibrate > Manual-Hand >
Start to begin. Rotate the lens
manually to the desired upper and
lower limits of your camera lens,
and select OK to confirm the limits.
This Quick Start Guide is subject to change without prior notice.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DJI Focus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DJI Focus in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DJI Focus

DJI Focus User Manual - English - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info