499506
37
Zoom out
Zoom in
Previous page
1/44
Next page
- 37 -
0DT829 15/10/2012
47E
ADJUSTMENT LIMIT SWITCH
Adjusting the limit switch
1. Set the deceleration ramps to zero. (T5 - T6)
2. Calibrate the limit switch (C) on the gearmotor so the door stops approximately
200-300mm from the closure point.
3. Calibrate the opening limit switch (A) at the opening point.
4. Calibrate slowdown limit switch (B) in such a way that it engages at
approximately ¾ of the opening stroke.
5. Calibrate the opening speeds using trimmer (T3) and closure (T4).
6. Calibrate the opening (T5) and closure (T6) trimmers of the deceleration
ramps in such a way as to cause stopping in the actual door open and door
closed positions.
C
B
A
B
C
300
A
¾
ON
J1
1
L N
GND
CNT
T2
T4
T6
T1
T3
T5
DL1011 9 8 7 6 5 4 3 2 1
12
15
1617
13
14
41 40 20 9 8 4 3 2 1 1 0 LAMP1 11 12 13
+F -F U V W
ON
OFF
1 2 3 4
U24
J2
F2F1
230 V 50/60 Hz
FUSES
ID Value Dimension Circuit
F1 - F2 12A - 500V 10.3 x 38 monophase line
COMMAND TROUBLE VERIFY

curtain position
The curtain and the motors
don’t move
Control unit test was failed
(led 13 green OFF, led 14 red ON)
Opening Command The motor run with slog or
it doesn’t reach to the right
speed (the brake wasn’t
activated)
Check that jumper J2 has not been cut
During the closing
movement
The motors doesn’t made
deceleration ramp
Adjustment of the closing limit switch (C) at 300 mm from
the oor
Adjustment of the deceleration ramp by means the trimmer T6
NB for general diagnostics see also at page. 39
TROUBLESHOOTING
EN
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DITEC Traffic C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DITEC Traffic C in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info