591001

Dirt Devil M3310 - Factory Manual

12
Zoom out
Zoom in
Previous page
1/24
Next page
12
2Use
2.3 Wet vacuum cleaning
WARNING:
Danger of injury! The same safety instructions that are specified under
ZChapter 2.2, “Dry vacuum cleaning“ apply. In addition the safety
instructions listed below apply only for wet vacuum cleaning.
ATTENTION:
Upon delivery both filters are mounted. Ensure that both filters are
mounted and undamaged for both dry vacuuming and wet vacu-
uming. If you are unsure, check this by proceeding as shown (Fig. 8,
Fig. 9, Fig. 10).
NOTE:
When you are finished with wet vacuum cleaning, allow the appliance to
run for 30 seconds longer so that any water in the hose can be trans-
ported into the tank.
ATTENTION:
For reasons of cleanliness and hygiene, we recommend that you empty
the dirt tank (ZChapter 3.1, “Emptying the dirt tank“) and clean the cen-
tral lamellae filter (ZChapter 3.3, “Cleaning the filter sleeve and central
lamellae filter“) after every wet vacuum cleaning task, and then let the
appliance dry.
8
9
a b
WARNING:
Danger of injury! When cleaning wet, smooth surfaces there is an
increased risk of slipping and falling. Pay attention and proceed with
care. Wear non-slip shoes. It is best to walk only on surfaces you have
already vacuumed.
ATTENTION:
Only operate appliance when it is standing vertically or held vertically.
Otherwise wastewater can run into the motor. In addition wastewater
can escape from the appliance.
NOTE:
The flat nozzle (Fig. 11/a) is only suitable for wet vacuum cleaning. The
wet and dry parquet nozzles (Fig. 11/a) can be used for both wet and
dry vacuum cleaning.
The two small accessory nozzles (Fig. 5) have been developed for dry
vacuum cleaning.
NOTE:
Clean the nozzle used immediately after wet vacuum cleaning. Particu-
larly if you are using the wet and dry parquet nozzle, if you want to use it
for dry vacuum cleaning as well.
10
11
a b
12
NOTE:
You can vacuum up a maximum of approx. 4 litres of liquid (Fig. 12),
before the integrated float seals the suction channel, to prevent a short
circuit. When the suction channel is sealed the appliance will make a
significantly higher pitched and louder noise. Liquid will no longer be
displaced.
If the integrated float block the suction channel:
1. Switch the appliance off and pull the plug out of the socket.
2. Allow the residual water to run out of the hose and into the dirt tank,
by lifting the hose until the water has run out of it.
3. Empty the dirt tank, ZChapter 3.1, “Emptying the dirt tank“.
4. You can immediately switch the emptied and completely assembled
appliance back on.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil M3310 - Factory at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M3310 - Factory in the language / languages: English, German, French as an attachment in your email.

The manual is 4,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info