500176
45
Zoom out
Zoom in
Previous page
1/76
Next page
45
9 Troubleshooting
GB
9 Troubleshooting
9.1 If the appliance does not work as it should
See if you can solve the problem yourself by following the steps in the table below. If you cannot
solve the problem using this table, contact our Service Hotline (ZPage 46) and describe the problem
to us.
Problem Possible cause / solution
The appliance will
not start.
The battery pack is inserted incorrectly.
Insert the battery pack correctly, ZChapter 4.3, ‘Inserting the battery pack’.
The battery pack is completely empty.
Switch off the appliance via the On/Off switch (position "0") and charge the
battery pack as described, ZChapter 5, ‘Charging the battery pack in the
appliance’.
The appliance was switched on (position "I") during the charging process.
Switch off the appliance via the On/Off switch (position "0") and switch it
back on again (position "I"). The appliance will then start up.
The cover of the dust container compartment has been taken off while the
appliance was still switched on.
Switch off the appliance via the On/Off switch (position "0") and switch it
back on again (position "I"). The appliance will then start up.
The cover of the dust container is not correctly seated. Switch off the appli-
ance via the On/Off switch (position "0") and correctly insert the cover of
the dust container compartment as described, ZChapter 8.4, ‘Inserting the
dust container and filter’.
The battery indicator
" " is illuminated
red.
The capacity of the battery pack is too weak.
Switch off the appliance via the On/Off switch (position "0") and charge the
battery pack as described, ZChapter 5, ‘Charging the battery pack in the
appliance’.
The appliance has no ground contact.
Place the appliance on the floor. It will now directly start cleaning.
The cleaning indica-
tor " " is illuminat-
ed red.
The dust container is overfilled or the filter is clogged.
Switch off the appliance via the On/Off switch (position "0") and proceed as
described under ZChapter 8, ‘After use’.
The appliance starts
up, but it continu-
ously moves back-
ward.
The slide controller for adjusting the sensitivity of the fall sensors is set on
a position for a light floor, although the appliance is being used on a dark
floor.
Adjust the setting of the slide controller to the sensitivity setting of the fall
sensors, ZChapter 6.1, ‘Adjusting the sensitivity of the fall sensors’.
The appliance only
cleans part of the
room to be cleaned.
Depending on the size of the room to be cleaned, the appliance may - at
the end of the 3 modes - not necessarily have been everywhere.
Let the appliance run until it has travelled over every area of the room.
Libero.book Seite 45 Montag, 12. März 2012 6:29 18
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil M 606 Libero at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M 606 Libero in the language / languages: English, German, French as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dirt Devil M 606 Libero

Dirt Devil M 606 Libero User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info