500166

Dirt Devil M 5080 - EQU Turbo Silence Manual

18
Zoom out
Zoom in
Previous page
1/30
Next page
18
6 Troubleshooting
6 Troubleshooting
6.1 Before you send in the appliance
Before contacting your authorised Royal dealer, Royal service partner or
appliance market or sending in the appliance, first follow the procedure in
the following table to check if you can solve the problem yourself.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the
appliance and disconnect it from the mains before starting troubleshoot-
ing Chapter 4.3, "Switching off".
No. Problem Possible cause Solution
1 The cleaning results are
not satisfactory although
the cleaning indicator
(Fig. 1/8) is green.
The bypass vent (Fig. 1/19) is open. Close the bypass vent (Fig. 1/19).
The attached nozzle is unsuitable. Change the nozzle, Chapter 3.2, "Selecting the proper nozzle".
The position of the ‘carpet/hard floor’
selector (Fig. 1/2) is unsuitable.
Set the "carpet/hard floor" selector (Fig. 1/2) to the correct position for the
type of floor, Chapter 4.2, "Vacuum cleaning", step 4.
The dust container is full. Empty the dust container, Chapter 5.1, "Emptying the dust container".
Nozzle, telescopic tube or suction
hose is blocked.
Remove the obstacle. If necessary, use a long wooden stick (e.g. a broom-
stick) to do this.
2 The cleaning indicator
(Fig. 1/8) suddenly begins
to slowly flash red during
cleaning.
The dust container has not been
emptied often enough, or the nozzle,
telescopic tube, or suction hose is
blocked.
1. Switch off the appliance and pull the plug from the mains socket,
Chapter 4.3, "Switching off".
2. Empty the dust container, Chapter 5.1, "Emptying the dust container".
3. Replace the dust container.
4. Plug the plug into a socket and turn the clean and fully-assembled vacu-
um cleaner back on.
5. If the cleaning indicator (Fig. 1/8) flashes red for more than thirty seconds
after being switched back on despite the dust container being empty, then
you also have to clean the components of the vacuum cleaner, Chapter
5.2, "Cleaning the dust container and cyclone unit" and Chapter 5.3,
"Cleaning the dual motor protection filter".
6. Take this opportunity to remove the nozzle, telescopic tube, or suction
hose from the appliance and remove any blockages (e.g. with a broom
stick).
7. Plug the plug into a socket and turn the clean and fully-assembled vacu-
um cleaner back on. The cleaning indicator (Fig. 5/5) will continue to flash
red slowly for 20–30 seconds (self-analysis mode) and will then change
to green (operational).
3 The cleaning indicator
(Fig. 1/8) slowly flashes
red for 20–30 seconds af-
ter being switched back
on.
This is normal. Your vacuum cleaner
performs a self-analysis during this
time.
After 20–30 seconds the cleaning indicator (Fig. 1/8) turns back to green.
4 The cleaning indicator
(Fig. 1/8) slowly flashes
red for longer than 30 sec-
onds after being switched
back on.
The cleaning carried out was not suf-
ficient.
Proceed in accordance with the solution for problem no. 2.
5 The cleaning indicator
(Fig. 1/8) flashes red fast
after flashing red slowly
for a while during clean-
ing.
The dust container has not been
emptied often enough, or the nozzle,
telescopic tube, or suction hose is
blocked. If you do not react soon, the
integrated protective mechanism in
the vacuum cleaner will turn the ap-
pliance off automatically before it
overheats.
Proceed in accordance with the solution for problem no. 2.
6 The appliance suddenly
stops vacuuming and the
cleaning indicator (Fig. 1/
8) continues to flash red
fast.
The protective function in the vacu-
um cleaner, which turns the appli-
ance off before it overheats, has
been triggered because you contin-
ued to vacuum even though the
cleaning indicator was flashing red,
meaning there was a risk of over-
heating.
Proceed in accordance with the solution for problem no. 2.
NOTE:
If you cannot solve the problem following these instructions, contact our customer services (contact Page 60, "International Service").
M5080.book Seite 18 Dienstag, 24. April 2012 10:48 10
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil M 5080 - EQU Turbo Silence at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M 5080 - EQU Turbo Silence in the language / languages: English, German, French as an attachment in your email.

The manual is 6,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info