320836
12
Zoom out
Zoom in
Previous page
1/21
Next page
12
Maintenance
Infinity VS8 Loop
4 Maintenance
4.1 Emptying the dust container
Empty the dust container after each
vacuuming session, but at the latest when the
"MAX" mark (Fig. 17/1) has been reached.
1. Remove the dust container by pushing the
release button (Fig. 17) and then remove
the dust container from its console.
2. Empty the dust container by holding it low
over a dust bin and only then push the
release catch of the bottom plate (Fig. 18/
A1).
3. On this occasion, also take out the cyclone
unit by unlatching it as shown (Fig. 18/B,
the arrow will move from to ).
4. Remove any residual dust that may have
collected in the dust compartment.
5. Clean the cyclone unit by wiping it with a
dry cloth or by brushing it with a dry soft
brush, e.g. the furniture brush supplied with
the appliance.
6. Replace the cyclone unit and secure it by
turning clockwise (the arrow will move from
to ).
7. Fold the bottom plate back up.
8. Also check the dual motor protection filter
on this occasion. Clean it if necessary,
Zchapter 4.4, „Cleaning the dual motor
protection filter“.
9. Put the dust container back into its holder.
You must feel and hear it click into place.
4.2 Overview of the filters
The filters can get dirty during use and
therefore must be checked regularly:
Keep the checking and cleaning intervals
given below.
Clean the filters as described below.
Damaged or deformed filters, however,
must be replaced immediately.
The following 2 filters are installed:
Dual motor protection filter (Fig. 19/1)
- Checking: Check the dual motor
protection filter for dirt and possible
damage every time you empty the dust
container.
- Cleaning If during checking you see that
the filter is dirty, clean it as described
below (Zchapter 4.4, „Cleaning the dual
motor protection filter“). However, the
filter should be cleaned at least every 3 –
6 months.
Exhaust filter (Fig. 19/2)
- Checking: Check the exhaust filter
regularly for dirt and possible damage, at
least every 3 – 6 months.
- Cleaning: If during checking you see that
the filter is dirty, clean it as described
below.
4.3 Cleaning the exhaust filter
1. Switch off the appliance.
2. Push the release catch of the exhaust filter
cover to the side and fold down the exhaust
filter cover (Fig. 20).
3. Remove the exhaust filter.
4. Clean the hygienic exhaust filter by tapping
out the dirt over a dustbin. Should this be
insufficient, clean the the filter with a soft
brush, e.g. the furniture brush supplied with
the appliance.
If this dry cleaning is still insufficient, then
rinse the filter in clear cold water.
5. If the filter is damaged or deformed, replace
it. (Zchapter 6, „Spare parts“).
6. Put the clean exhaust filter back into its
holder.
7. Attach the exhaust filter cover at the bottom
side first and then fold it shut.
8. To secure it you must guide the latch by
hand as during unlatching until you hear
and feel it snap into place.
4.4 Cleaning the dual motor
protection filter
1. Switch off the appliance, remove the dust
container and empty it Zchapter 4.1,
„Emptying the dust container“.
2. Open the latch of the motor protection filter
cover and take out the dual motor
protection filter (Fig. 21).
3. Hold the dual motor protection filter deep
inside a dustbin and only then separate the
filter elements from each other.
4. Thoroughly rinse both filter elements by
hand with clear cold water.
5. If a filter element is damaged or deformed,
replace it by a new one. (Zchapter 6,
„Spare parts“).
6. Put the filter elements back together again.
7. Close the motor protection filter cover by
folding it shut. The latch must snap shut.
8. Put the dust container back into the
appliance. It must catch with a click.
ATTENTION:
Switch off the appliance before emptying the
dust container. This will prevent dust from
damaging the appliance.
NOTE:
You can dispose of the dust filter bag with
your regular domestic trash as long as it
contains no waste materials prohibited in
domestic trash.
MAX
1
17
1
AB
18
1
2
19
20
ATTENTION:
The filter is washable, but not suitable for
cleaning in washing machines or
dishwashers. Also, do not use cleansers for
cleaning the filters. Leave the filter element
to dry after cleaning (approx. 24 hours at
room temperature). Only put it back into the
appliance when it is completely dry.
ATTENTION:
The filter elements are washable, but not
suitable for cleaning in washing machines or
dishwashers. Also, do not use cleansers for
cleaning the filters. Then leave the filter
elements to dry (approx. 24 hours at room
temperature). Only put them back into the
appliance when they are completely dry.
21
Infinity VS8.book Seite 12 Mittwoch, 23. Februar 2011 11:58 11
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil m 5038 1 carbon infinity vs8 loop at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil m 5038 1 carbon infinity vs8 loop in the language / languages: English, German, Dutch, French, Italian, Turkish, Spanish as an attachment in your email.

The manual is 1,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info