321256

Dirt Devil m 2700 4 centrino sx 3 Manual

13
Zoom out
Zoom in
Previous page
1/24
Next page
13
4 Maintenance
GB
4 Maintenance
4.1 Overview of the filters
The filters can get dirty during use and therefore must be checked regularly:
Clean the filters as described below.
Keep the checking and cleaning intervals given below.
Replace damaged or deformed filters immediately.
Your appliance is equipped with the following 4 filters (Fig. 13):
Cyclone (Fig. 13/1)
- Checking: Every time you empty the dust container.
- Cleaning: according to the degree of soiling, but at least once per month
Zchapter 4.2, „Checking and cleaning the cyclone“
Foam plastic Motor protection filter (Fig. 13/2)
- Cleaning: according to the degree of soiling, but at least once per month
Zchapter 4.3, „Cleaning / changing the laminar motor protection filter“
- Changing: every 6 months
Zchapter 4.3, „Cleaning / changing the laminar motor protection filter“
Laminar motor protection filter (Fig. 13/3)
- Cleaning: according to the degree of soiling, but at least once per month
Zchapter 4.3, „Cleaning / changing the laminar motor protection filter“
- Changing: every 6 months
Zchapter 4.3, „Cleaning / changing the laminar motor protection filter“
Exhaust filter (Fig. 13/4)
- Cleaning: according to the degree of soiling, but at least once per month
Zchapter 4.4, „Cleaning / changing the exhaust filter“
- Changing: every 6 months
Zchapter 4.4, „Cleaning / changing the exhaust filter“
4.2 Checking and cleaning the cyclone
1. Switch off the appliance Zchapter 3.1, „Switching off“.
2. Remove and empty the dust container, Zchapter 3.4, „Emptying and cleaning the dust container“.
3. Hold the dust container low over a dustbin.
4. Check the cyclone for possible dirt.
5. If the cyclone is dirty, twist it out of its receptacle (Fig. 14/1.) and take it out (Fig. 14/2.).
6. If necessary, rinse the cyclone in clear cold or hand warm running water until all dirt is removed (Fig. 15/A).
7. Also check and if necessary clean the foam plastic motor protection filter, the laminar motor protection filter
Zchapter 4.3, „Cleaning / changing the laminar motor protection filter“ and the exhaust filter Zchapter 4.4,
„Cleaning / changing the exhaust filter“.
8. Refitting the cyclone into the appliance:
- The cyclone has two tabs of different size that must engage the corresponding grooves of the dust
container.
- Position the cyclone in such a way that the larger of the two tabs engages the larger groove of the dust
container (Fig. 16/1.), the smaller tab the smaller groove accordingly.
- Now lock the cyclone by twisting it in the direction indicated by the arrow (Fig. 16/2.).
9. Close the dust compartment bottom plate.
10. Put the dust container back into its holder. You must feel and hear it clicking into place.
11. Check that the dust container is fitted securely.
4
1
2
3
13
ATTENTION:
The cyclone is washable, but may not be cleaned in dishwashers. Also, do not use detergents or brushes
with hard bristles to clean the filters. Dry the cyclone with a cloth or leave it to dry at room temperature for
approx. 24 hours after cleaning (Fig. 15/B). Only put it back in place when it is completely dry.
1.1.
2.2.
14
24
19
18
17
16
15
14
20
21
22
23 13
15
2.
1.
1.
16
M2700.book Seite 13 Mittwoch, 6. April 2011 2:50 14
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil m 2700 4 centrino sx 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil m 2700 4 centrino sx 3 in the language / languages: English, German, Dutch, French, Italian, Turkish, Spanish as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info