500165
14
Zoom out
Zoom in
Previous page
1/24
Next page
14
4 Maintenance
4.3 Cleaning / changing the laminar motor protection filter
1. Switch off the appliance Zchapter 3.1, „Switching off“.
2. Remove the dust container Zchapter 3.4, „Emptying and cleaning the dust container“.
3. Hold the dust container low over a dustbin.
4. Push the release catch of the holder of the foam plastic motor protection filter (Fig. 17/1) and fold it
downwards.
5. Pull the foam plastic motor protection filter out of its holder (Fig. 17).
6. Also remove the laminar motor protection filter (Fig. 18/arrow) from its receptacle.
7. For a rough cleaning, tap the dirt from both filter elements by lightly beating them over a dustbin.
8. Remove larger agglomerations of dirt by hand.
9. Should this be insufficient, clean the the filter with a soft brush, e. g. the furniture brush supplied with the
appliance.
10. If the filter elements are still dirty after this procedure, thoroughly rinse them by hand (Fig. 19/A) until all
dirt has been removed. Only running cold or lukewarm water to rinse the filter elements.
11. If a filter element is damaged or too dirty, replace it with a new one (ordering information Zchapter 5.2,
„Accessories/Spare Parts“).
12. Put the new / cleaned and completely dry motor protection filter back into its receptacle (Fig. 20). Use both
hands to push it into its proper position (Fig. 20/arrows).
13. Put the new / cleaned and completely dry foam plastic motor protection filter back into its holder (Fig. 17).
14. Fold the filter holder back up against the dust container until you feel and hear the release catch of the filter
holder (Fig. 17/1) snap into place.
15. Put the dust container back into its receptacle. You must feel and hear it clicking into place.
16. Check that the dust container is fitted securely.
4.4 Cleaning / changing the exhaust filter
1. Switch off the appliance.
2. Push the release catch of the exhaust filter cover to the right (Fig. 21/arrow) and fold down the exhaust filter
cover.
3. Remove the exhaust filter (Fig. 22).
4. Knock the exhaust filter over a dustbin for a rough cleaning.
5. Remove larger agglomerations of dirt by hand.
6. Then thoroughly rinse the filter Only rinse the filter in clear running cold or hand-warm water.
7. Ifthe filter is damaged or deformed, replace it.(ordering information Zchapter 5.2, „Accessories/Spare
Parts“).
8. Put the new / cleaned and completely dry exhaust filter back into its receptacle.
9. Fit the exhaust filter cover on the right side first and then fold it in to the left.
10. Check the cover for correct fit.
ATTENTION:
The filter elements are washable, but may not be cleaned in dishwashers or washing-machines. Also, do not
use detergents or brushes with hard bristles to clean the filters. Let the filter elements dry for approx 24 hours
at room temperature after cleaning (Fig. 19/B). Only put them back into the appliance when they are
completely dry.
1
17
18
24
19
18
17
16
15
14
20
21
22
23 13
19
20
ATTENTION:
The filter is washable, but it may not be cleaned in dishwashers or washing-machines. Also, do not use
detergents or brushes with hard bristles to clean the filters. Let the filter dry for approx 24 hours at room
temperature after cleaning it. Only put it back in place when it is completely dry.
21
22
M2011-4_Centrino XL3_7lang_20110615.pdf 14 15.06.2011 18:22:28
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dirt Devil M 2011 - Centrino XL3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M 2011 - Centrino XL3 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info