23
© 2005 directed electronics, all rights reserved
6. Feature change - Press the button on the remote. If
the system chirps once, the feature has just turned off or
switched to the first setting in the grid slot for this feature;
if the system chirps twice, the feature has just turned on or
switched to the second setting in the grid slot.
If the feature has more than two settings, continue pressing
the on the remote to toggle through the settings
(e.g. if the feature has 1 through 5 settings, the system will
chirp 1 through 5 times for each setting selected). If you
continue to press and release the remote the feature setting
will wrap back around to the first setting again. (e.g. if the
feature has 3 settings you will hear, 1 chirp, 2, chirps, 3
chirps, 1 chirp, 2 chirps, etc).
To advance to another feature in the same column, press
the same number of times as the desired feature with-
in 60 seconds; to change a feature in a different column
begin at step 5 by entering the column number first and
then the feature select in step 6.
7. Exit programming - To exit programming mode turn the igni-
tion off or wait 60 seconds without pressing the Valet but-
ton. The siren will chirp three times to indicate programming
mode has been exited.
After you change a feature setting, the feature counter is reset to zero.
Hence, to change another feature in the same column you must press
the button the same number of times as indicated in the chart
below.
nnoottee::
Refer to the Feature Descriptions sections of this guide for impor-
tant notes and descriptions of the system features and programming.
