7
© 2005 directed electronics, all rights reserved
While the system is armed, the LED status indicator will flash approxi-
mately once per second showing that the system is actively protecting
your vehicle. If you hear more than one chirp when arming, refer to the
Diagnostics section of this guide. These extra chirps confirm a malfunc-
tion autobypass.
The security system also can be programmed to arm itself
automatically without a remote (called passive arming). If the system is
programmed for passive arming, it will automatically arm 30-seconds
after the ignition is turned off. Whenever the system is in its 30-second
passive-arming countdown, the siren will chirp once and the lights will
flash once five seconds after countdown has commenced. This is indi-
cated by the rapid flash from the status LED. The system is not actually
armed at that point. The system arms after the 30-second countdown
has elapsed, but the siren will not chirp. The early chirps provide you
with a 25-second warning prior to arming.
When armed, your vehicle is protected as follows:
z
The LED will flash as a visible theft deterrent.
z
If the tilt sensor detects the motorcycle is being moved in an
attempt to steal it, the system will immediately trigger the
siren and flash the indicator lights.
This sensor is capable of independently learning the bike’s ini-
tial angles of vertical and horizontal inclination each time it is
parked, ensuring the most accurate tilt (vertical and horizon-
tal) sensing possible.
z
If a protected switch is opened, the system will immediately
trigger the siren and flash the indicator lights.
z
The immobiliser prevents the motorcycle’s engine from starting.
nnoottee::
If one of the zone 4 or 5 switch inputs is active or the ignition is
on, the system will not passively arm. Additionally, if one of these
switches is activated or the ignition is turned on, the countdown will
cease, then begin again when the input is removed.
