583790
31
Zoom out
Zoom in
Previous page
1/52
Next page
31
© 2008 Directed Electronics. All rights reserved.
Valet take-over
The Valet take-over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet take-over:
Before turning off the engine, press and release 1.
A U X
on the trans-
mitter. Then wait a few seconds.
Turn the ignition key to the OFF position (The engine will stay 2.
running).
The engine will run until the pre-programmed time elapses or a 3.
shut-down input is received.
Note:
To enable Valet take-over with a manual transmission, open the
door and enter into manual transmission mode, as described above.
The parking lights ash ve times when entering Valet take-over. Once
you exit the vehicle you can lock the system and the car will remain
running. If the vehicle shuts down when locking, then the unit did not
enter valet take-over mode.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Directed Electronics 1601 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Directed Electronics 1601 in the language / languages: English as an attachment in your email.

The manual is 5,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info