706502
6
Zoom out
Zoom in
Previous page
1/8
Next page
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth.
DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush
attachment of a vacuum cleaner should occasionally be
used to clean the outlet grille of the fan heater.
WARNING: do not operate the product without the grille
and outer glass in position as this may effect the operation
of the heater.
Recycling
For electrical products sold within the
European Community. At the end of the
electrical products useful life it should not
be disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice in your country.
Servicing
Except for installation and cleaning described in this
manual, an authorized service representative should
perform any other servicing.
Fuel Bed Media
Acrylic Ice Crystals and White Pebbles are supplied in the
box with your re. allowing you the option of which to place
on your re. To Fit the Acrylic Ice Crystals, place the small
Crystals on the fuel bed tray, then place the larger crystals
on top of the small pieces. Arrange the larger pieces to your
liking. A suggestion is to place one large crystal centrally on
the fuel bed and the other four positioned symmetrically
around this piece.
The White pebbles are placed on the fuel bed tray until the
tray is completely covered by pebbles to your liking.
Fitting the Front Glass- See Fig. 5
Your new re is supplied with the front glass not secured to
the engine, this is to keep the glass safe in transit. To t the
glass to your re, simply insert the four hangers on the back
of the glass through the slots provided on the chassis. The
hangers go in through the slots and then move down to
hold the glass in place. The glass can then be secured in
place by inserting the small black screw provided through
the hole in any one of the hangers into the side of the unit.
Thermal Safety Cut-out
The built-in overheat cut-out switches the appliance off
automatically in the event of a fault. If this occurs switch off
the appliance or disconnect the mains plug from the socket.
After a short cooling down phase, the appliance is ready for
use again. If the fault should occur again, see your local dealer.
Light Emitting Diode
This re is tted with LED (Light Emitting Diode) bulbs in place
of traditional incandescent bulbs. These generate the same
light levels as traditional bulbs, but use a fraction of the energy
consumed.These bulbs cannot be replaced.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Toluca DeLuxe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Toluca DeLuxe in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info