648151
11
Zoom out
Zoom in
Previous page
1/32
Next page
www.dimplex.de/en NDPGEP5RG · 07/14/B EN-11
English
PLX 500, PLX 750, PLX 1000, PLX 1500, PLX 2000TI, PLX 2500, PLX 3000
5. Heater Operation
The heater controls are protected underneath a looking
cover. To open the cover, turn the look in clockwise di-
rection. Once the desired functions have been se-
lected, the cover must be locked again.
.
5.1 Heaters without timers
The power switch (0-I) is used to switch the heater on
and off. The off-position and off. The off-position is
identified by „0“.
The switch marked I-II (except PLX500) provides a
choice of heat output: I half heat or II full heat.
Thermostat Selector switch On/Off
5.2 Thermostat
The heater is fitted with an electronic thermostat by
means of which the room temperature can be con-
trolled by choosing a suitable setting. The setting cor-
responds to a room temperature of approximately 6 °C
(frost protection setting). Higher temperature settings
range from 1 to 6 max.
The neon indicator light shows when the appliance is
actually heating.
NOTENOTE
If you do not switch on your heater may have a cause,
that the slider of the thermostat is set at a lower
temperature than the current room temperature
ATTENTION!
Depending on room size, heat demand and
thermostat setting, rooms can be heated over a
silent heating. This may cause a danger to persons
who are not able to leave the room in case of
excessive temperature.
5.3 Heaters with Timer
The heater is switched on by the slide located to the left
of the timer. In position the convector is operated
manually, i.e. without timer.
Position
means automatic operation, i.e. the con-
vector is switched on and off automatically by the timer.
The thermostat ensures a uniform room temperature
during the operation duration.
No heating operation takes place outside the pre-set
operating time (frost protection is also deactivated).
Setting the clock:
Rotate the timer‘s dial in clockwise direction until the
current time is aligned with the marking
.
Heater On: Push the appropriate segments out.
Heater Off: Push the segments in.
Each segment represents an on-or off-period of 20 min-
utes. For example, to set an operating duration of 2
hours, 6 segments need to be pushed outwards.
The timer can be programmed for several „On/Off“ time
periods of varying lengths.
Thermostat Selector switch Automatic/Off/Manual Timer
6. Overheat Protection
The heater is equipped with an overheat protection for
your safety. If the air circulation is impeded, the heater
is switched off by the overheat protection. Once the
heater has cooled sufficiently, it will automatically
switch on again
In the event that the overheat protection trips re-peat-
edly, the cause of overheating must be determined,
e.g. air grille is covered or obstructed.
For maximum heat output it is essential that you keep
the air inlet and outlet openings free of dust. Clean the
heater with a vacuum cleaner before the start of the
heating season!
7. Malfunctions
If there is no heat output from the unit, please check
that the heater is switched on and that the thermostat is
set to the desired temperature. Subsequently check
the circuit breaker on the main service panel, or the
fuse, to ensure that they have not tripped or blown.
0
2
1
3
4
5
6
O
2
1
3
4
5
6
12
13
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex PLX 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex PLX 500 in the language / languages: English, German, French, Polish as an attachment in your email.

The manual is 0.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dimplex PLX 500

Dimplex PLX 500 Usermanual and installation guide - Dutch, French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info