798105
4
Zoom out
Zoom in
Previous page
1/24
Next page
ELECTRICAL CONNECTION
WARNING THIS APPLIANCE MUST BE EARTHED
Assembly and Positioning
FITTING THE CASTORS
WARNING The radiator must only be operated
with the wheels and castors tted and in the
upright position.
The castors must be tted to the control panel and between the
last and second last n on the opposite end, as shown in Fig.1.
To t the castors, turn the radiator upside down on a carpet or
other soft surface to avoid damage.
WARNING The radiator is heavy – ensure that
it is supported to prevent it from toppling. Ask
a second person to help with this if necessary.
Locate the wire clamp (A) and remove the winged nut (C).
Insert the non threaded end of the wire clamp into one of the
holes in the castor plate (B) as shown. Feed the threaded end
of the wire clamp between the last and second last column ns
ensuring the wire clamp wraps around the column body (sump).
some manipulation of the plate and clamp will be required. The
threaded end should then be passed through the castor plate
and secured using the wing nut.
To t the castor to the control end, position the castor plate in
position and secure using the wing bolts (D). there are guides to
ensure the correct positioning and orientation of the caster plate.
Return the radiator to the correct orientation so it rests on the
castors. The product is now ready for use.
POSITIONING THE HEATER
Select the position for the heater ensuring there is clearance
from any furniture and ttings of at least 300mm above the
heater and 150mm each side and 300mm from the control and
end panel. We recommend maximising the clearance where
possible.
Models & General Information
MODELS
Model Description Power
(W)
OCR1500 7 n, thermostat, three heat settings &
Neon 1500
OCR2000 9 n, thermostat, three heat settings &
Neon 2000
OCR2500 11 n, thermostat, three heat settings &
neon 2500
GENERAL
The radiator is designed for operation on an AC electricity
supply, and is suitable for use in domestic dwellings and similar
indoor locations.
The radiator is tted with castors and a handle for ease of
movement. A rotary selector switch provide the ability to
choose an available heat output and an adjustable thermostat
enables the room temperature to be controlled accordingly. It
is supplied with a cord and plug and is ready for use once the
castors have been correctly tted.
Operation
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE
PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and instructions
have been read carefully.
Once the castors have been tted, to activate the heater
simply plug it in. Neon indicating lights (i, see Fig 2) located at
the controls area will illuminate when the appliance is plugged
into the mains. This indicates the appliance is energised and
ready for use.
CONTROLS
(See Fig.2 &3)
Thermostat (T)
The Thermostat controls the heat output according to the room
temperature. This ensures that the heater will not produce heat
unnecessarily when the room is warm. To set the temperature
you require, turn the thermostat knob clockwise until the
required setting is reached. Alternatively to heat a cold room
quickly, turn the thermostat knob up fully. When the room
has reached the desired temperature, turn the thermostat
knob anti-clockwise until the thermostat just clicks off. The
heater will now automatically operate at this temperature. The
thermostat also has a frost protection setting marked ‘ ‘.
This setting is useful in areas such as garages, to prevent frost
damage. If the thermostat is set to its minimum setting ‘ ’,
the heater will cycle on and off to maintain a temperature of
approximately 5° to help protect against frost.
Note – Should the heater fail to come on when the thermostat
is at a low setting, this may be due to the room temperature
precise quantity of special oil. Repairs requiring
opening of the oil container are only made by
the manufacturer or his service agents.
When scrapping the appliance, the oil must be
disposed of properly! As this is a category 2 oil, it
must be disposed of only at waste oil collecting
points.
DO NOT use the heater on deep pile carpets or
the long hair type of rugs, or less than 750mm
(30”) away from any overhanging surface. Keep
combustible materials such as drapes and other
furnishings clear from the front, sides and rear of
the heater. Do not use heater to dry your laundry.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex OCR2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex OCR2000 in the language / languages: English, German, Dutch, French, Italian, Polish, Norwegian as an attachment in your email.

The manual is 7.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info