706557

Dimplex Juneau Manual

11
Zoom out
Zoom in
Previous page
1/36
Next page
5
Additional Information
Recycling.
For electrical products sold within the European Community. At the end of the electrical products useful life it
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service, please get in touch with the supplier through whom you purchased the
appliance.
Symptom Cause Corrective Action
The ame effect will
not start.
Mains plug is not plugged in.
Switch A is in the ‘ON’ (I) position, but mode
Switch B has not been pressed. (See Fig.2)
Low water level.
Low voltage connector not connected
properly. (See Fig.8)
Check plug is connected to wall socket
correctly.
Press Switch B once for ame effect. (See
Fig.2)
Check the water tank is full and there is
water in the sump.
Check that the connector is inserted
correctly. (See Fig.8)
The ame effect is too
low.
Flame effect control knob is set too low.
(See Fig.2)
The water in the sump may be too high due
to the drawer being opened and closed
a number of times, water tank removed
a number of times, or the re has been
moved.
Metal Disc at the base of Sump might be
dirty (See Fig.13)
Increase level of ame by turning Control
knob C to the left slowly. (See Fig.2)
If water level in the sump is more than
40mm, the sump should be removed and
emptied in the sink.
Clean Metal Disc with soft brush supplied.
(See Fig.13) See ‘Maintenance.’ for a step by
step procedure.
Unpleasant smell
when unit is used.
Dirty or stale water.
Using unltered tap water.
Clean the unit as described under
maintenance.
Use tap water with a maximum hardness of
10 dH only.
The ame effect has
too much smoke.
Flame effect setting is too high. Turn the ame effect Control knob C to the
right until it is at minimum and slowly turn to
the left, about ¼ a turn, at a time. Give the
ame generator some time to adjust before
increasing. (See Fig.2)
Main lamps are not
working and there are
no ames or smoke.
There is no water in the tank. Follow instructions under Maintenance, ‘Fill-
ing the water tank’.
Check the plug is connected to wall socket
correctly.
Switch ‘A’ Fig. 2 is in the ‘ON’ ( I ) position.
Press switch ‘B’ Fig.2 until you can hear one
beep only, for ame effect.
Troubleshooting
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Juneau at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Juneau in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info