706555

Dimplex Hemmet Manual

8
Zoom out
Zoom in
Previous page
1/52
Next page
- 2 -
Installation Instructions
Before installing this appliance, we recommend that;
1. You have your chimney cleaned by a competent
chimney sweep.
2. You block o the chimney  ue.
This procedure is important for the e cient operation
of the heating unit and will also reduce heat loss up the
chimney.
Installation.
Ensure that all packing items are removed (read any
warning labels carefully).
Retain all packing for possible future use, in the event
of moving or returning the appliance to your supplier.
To install the appliance;
1. Remove the  replace grate, ashpan etc.
2. The ashbed grate should be stored away for possible
future use.
3. Clean the hearth of any ash residue or dust etc.
At the rear of the appliance, two adjustable supports are
provided for levelling, where the base of the  replace
opening is raised above the level of the hearth.
You are now ready to install the electric  re into your
replace.
Make sure the unit is switched OFF.
Hold the  re by the sides of surround and gently
manoeuvre into position. Plug the  re into a 13amp/240
volt outlet. Ensure that the supply cable exits at the front
of the  re, at the right or left hand corner to suit your
supply socket location and is not trapped under the  re
such that it might cause it to be damaged.
Before using the manual controls  rstly ll the water
tank (See ‘Maintenance’, ‘Filling the water tank’).
Manual Controls.
The Opti-myst Manual controls are located beneath the
hinged canopy cover. Raise the canopy cover to access the
controls. (See Fig. 2 for Manual Control lay out)
Switch ‘A’:- Controls the electricity supply to the heater.
Note: This switch must be in the ‘ON’ ( I ) position for the
heater to operate with or without heat.
Switch ‘B’:- Controls the function of the  re.
Press
once to turn on  ame e ect. This will be
indicated by one beep.
Although the main lights operate immediately it will
take a further 30 seconds before the  ame e ect starts.
Press again to give  ame e ect and half heat.
This will be indicated by two beeps.
Press
again to give  ame e ect and full heat. This
will be indicated by three beeps.
Press
again to return to  ame e ect only.
This will be indicated by one beep.
Press to put  re in to standby mode.
This will be indicated by one beep.
Control Knob ‘C’:- Controls the intensity of the  ame
e ect.
Turning the control knob Clockwise increases the  ame
e ect, turning the control knob Anti Clockwise will
decrease the  ame e ect.
Control Knob ‘D’:- Controls the Electronic Thermostat
setting.
Turning the control knob Clockwise will decrease the
temperature setting, turning the control knob Anti
Clockwise will increase the temperature setting.
When the water is empty the main lamps go out. See
instructions under ‘Maintenance’, ‘Filling the water tank’.
When this procedure is complete, the main lamps will
illuminate but it will take 30 seconds before the  ames
return.
Electronic Thermostat
The thermostat controls the heat output according to
the room temperature. This ensures that the heater
will not produce heat unnecessarily when the room is
warm.
To set the temperature you require, turn the thermostat
control knob ‘D’ (See Fig. 2) Anti-Clockwise until the
desired temperature is reached. Alternatively to heat
a cold room quickly, turn the thermostat control knob
‘D’ (See  g. 2) up fully. When the room has reached the
desired temperature, turn the thermostat control knob
‘D’ (See Fig. 2) clockwise until the desired heat setting is
achieved.
The heater will now automatically operate at this
temperature.
Remote Control Operation
On the control panel, Switch A (see Fig. 2) must be in the
‘ON’ ( I ) position in order for the remote control to operate.
There are 3 buttons on the remote control. (See Fig. 7)
To operate correctly the remote must be pointed towards
the front fuel e ect.
The remote control functions are as follows:
Press once to turn on Flame e ect only.
This will be indicated by one beep.
Press once to turn on Half heat and Flame e ect.
This will be indicated by two beeps.
Press again to turn on Full heat and Flame e ect.
This will be indicated by three beeps.
Standby
This will be indicated by one beep.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Hemmet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Hemmet in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info