499324
4
Zoom out
Zoom in
Previous page
1/8
Next page
6
5. L.E.D. DISPLAY Indicates the temperature or the time setting. After any time set
the display will return to the preset temperature automatically.
6. SPEED Press to select either LOW, MEDIUM, HIGH or AUTO fan speed.
If "AUTO" is selected, the unit operates at maximum cooling
capacity when the room temperature less the set temperature
is above 2.
When the room temperature less the set temperature is below
2, the unit operates at middle cooling capacity.
When the room temperature equal the set temperature, the
unit operates at minimum capacity.
If "HIGH" is selected, the unit operates at maximum cooling
capacity no matter what the setting temperature is . The
"MEDIUM" OR “LOW" comes to the same.
7. PROGRAMMABLE Programmable timer ON/OFF key.
TIMER TIMER-ON: The timer-on is used to turn on the unit automati-
cally after the set time is over.
(Timer-on key is correspond to the functional indicator light)
1. Press the "TIMER" key at stand-by status to set the time.
Choose the function desired(refrigeration, heat or
dehumidification.)
2. Once the set hour has come to an end, the unit will turn on
automatically.
3. Press the "POWER" key before time out, the setting time will
be cancelled and the unit will turn on.
TIMER-OFF: The timer-off is used to turn off the unit automati-
cally after the setting time is over.
Error Display
E1: Indicates open circuit or short circuit in room temperature sensor.
E2: Indicates open circuit or short circuit in pipe temperature sensor.
E7: Indicates the water is full inside.
Please contact a authorized service centre if any of the above error messages are shown.
7
8. SLEEP CONTROL When setting the "sleep comfort" mode please ensure that you
FUNCTION then set the number of hours required and press the timer
button till those hours are indicated on the L.E.D display. After
setting the hours the L.E.D. display will automatically return to
the current pre-set temperature. To increase this setting press
the "UP" button for each press, the temperature will be increased
by 1. Likewise to set for a lower temperature, press the button
indicating “DOWN”, and for each press the temperature will be
decreased by 1.
During the course of this cycle, to ensure maximum sleep
comfort. the micro-processor memory will raise the pre-set
temperature 0.5 each half hour to a maximum of 2 over two
hours and then maintain that temperature for the balance of the
time set.
The portable air conditioner is fitted with a 3 minutes compressor
delay protection circuit which simply means that the compressor
requires 3 minutes to start. From either being switched on, or
when changing from “dehumidify” to any air conditioning cycle
chosen.
9.”E7” When the unit warns of full water, please unplug the water
stopper at the back of the unit and then lean the unit to drain the
water out. Then the unit can be restarted. If the E7 is presented
again, please find a specialized person to repair.
GDC-AC9RCS/GDC-AC9RCW/GDC-AC12RCB/GDC-AC12RCW with heating
function
Note: Heating function does not operate if the ambient temperature is over 23
℃.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex GDC-AC12RW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex GDC-AC12RW in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info