798072
6
Zoom out
Zoom in
Previous page
1/28
Next page
EN-6 2203/A www.dimplex.eu
English DX 521, DX 522 T
ATTENTION!
If the device switches on automatically unsu-
pervised, risks may arise, e.g. devices that
have been covered or adjusted could result
in fires!
ATTENTION!
Do not use the device on long-pile carpets.
Keep flammable objects, such as curtains or
other textiles, a sufficient distance away
from the heating device. Do not use the de-
vice for drying clothes!
NOTE
i
Use device for room heating within enclosed rooms
only.
2. Installation
ATTENTION!
Do not set up the device directly below a wall
socket.
ATTENTION!
Only set up the device on a horizontal, stable
surface.
The minimum clearances must be observed.
In addition, a clearance of 750 mm is to be maintained
in front of the unit.
The supply connection socket must be accessible
after installation.
Make sure that the inflow and outflow of air at the top
and bottom of the device are unimpeded.
2.1. Installation of the supporting feet
Do not install the heating device without the feet sup-
plied.
The two mounting screws for the supporting feet are
located on the bottom of the device.
Loosen the mounting screws.
Engage the supporting feet as shown in the illus-
tration and tighten the screws.
3. Electrical connection
The voltage specified on the type plate must match
the line voltage.
The cable must not be in contact with the casing.
The device must only be repaired by a qualified elec-
trician in accordance with the applicable safety regu-
lations.
Connect the device directly to an earthed socket. Do
not use an extension cable
The plug must always be accessible in case of emer-
gencies.
4. Operation
Both models have two rotary knobs.
The top rotary knob can be used to select three or four
heating levels depending on the model:
The room temperature is regulated using the infinitely
adjustable thermostat (bottom rotary knob).
If the rotary knob is set to the lowest setting i.e. to the
extreme left, the thermostat switches the heating de-
vice on at an ambient temperature of approx. 5 °C.
585
230
Min.
230
Min.
443
233
500
Min.

Mode Operation
OOff
I1.2 kW
II 2.0 kW
2.0 kW with turbo fan (DX 522 T only)
DX 522 T
rotary knob
DX 521
rotary knob
Turbo fan
(DX 522 T only)
Rotary knob for
selecting the
heating levels
Thermostat
rotary knob
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex DX521 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex DX521 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 9.87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info