798182

Dimplex DX421 Manual

7
Zoom out
Zoom in
Previous page
1/37
Next page
EN-7
English
DX 421, DX 422T, DX 431, DX 432T, DX 432T
ATTENTION!
Ensure there is a minimum of 230 mm below
the heater, 450 mm above the heater and
750mm in front of the heater of unobstructed
space.
ATTENTION!
In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance
must not be supplied through an external
switching device, such as a timer or
connected to a circuit that is regularly
switched on and off by the utility.
ATTENTION!
DO NOT use the heater on deep pile carpets or
the long hair type of rugs. Keep combustible
materials such as drapes and other furnishings
clear from the front, sides and rear of the heater.
Do not use the heater to dry your laundry.
2 Technical data
Connection voltage: 1/N/PE~, 230 V, 50 Hz
Protection type: IP20
Protection class: I (with protective conductor)
3 Installation
The heating device may only be installed as shown, i.e.
on a horizontal, even surface. Using it on deep-pile car-
pets is not permitted. Please use caution when install-
ing it in front of flammable objects. Installation below a
wall socket is not permissible. Minimum clearances
must be observed.
In addition, a minimum clearance of 750 mm between
flammable objects e.g. curtains, towels or heat-sensitive
plastics and the front of the unit must be maintained.
3.1 Installation of the supporting feet
Do not use the heating device
without the feet being fitted.
The two mounting screws for
the supporting feet (A) are lo-
cated on the bottom of the de-
vice. Loosen the mounting
screws.
Engage the supporting feet as
shown in the illustration and
tighten the screws.
4 Electrical Connection
The voltage specified on the type plate must match the
local mains voltage.
The device plug must always be accessible.
5Operation
The room temperature is regulated using the adjusta-
ble thermostat (C). If the rotary knob is set to the lowest
setting i.e. to the extreme left (see figure), the thermo-
stat switches the heating device on at an ambient tem-
perature of approx. 5°C.
The heating device is switched on and off using the
power switch (D).
Two heating levels (I = Low or II = High) can be se-
lected using the operating mode switch (E).
The red light illuminates when the device is in heating
operation.
ATTENTION!
Depending on the size of the room, heat requirement
and thermostat setting, rooms may overheat if the
heating is not controlled. This can be dangerous for
people who are not able to leave the room as it gets too
hot.
Type Heat out-
put (W)
Width
(mm)
Height
(mm)
Depth
(mm)
Weight
(kg)
DX 421 2000 575 350 200
4,1
DX 422T 2000 575 350 200
4,3
DX 431 3000 695 350 200
4,7
DX 432T 3000 695 350 200
5,1
DX 432Ti 3000 695 350 200
5,2
F
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex DX421 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex DX421 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 5.86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info