706523
23
Zoom out
Zoom in
Previous page
1/40
Next page
Always ensure that the re is sitting on a level oor.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this re or lay on its back, without draining the water from sump and water tank.
The water tank, sump, sump lid, tank cap and air lters must be cleaned once every two weeks, particularly in
hard water areas.
The re appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under ‘Maintenance’ and ‘Changing lamps’.
Ensure that all packing items are removed (read any warning labels carefully).
Retain all packing for possible future use, in the event of moving or returning the appliance to your supplier.
To reduce heat losses and to prevent any chimney updraught affecting the operation of your re we
recommend that the chimney ue is blocked off, ensure that there is a slight gap for ventilation.
To install the appliance;
Hold the re by the sides and gently manoeuvre into position. Plug the re into a 13amp/240 volt outlet. Ensure that
the supply cable exits at the front of the re, at the right or left hand corner to suit your supply socket location and is
not trapped under the re such that it might cause it to be damaged.
Before switching on the appliance, please read the following instructions.
Before using the manual controls rstly ll the water tank (See ‘Maintenance’, ‘Filling the water tank’).
Manual Controls.
The manual controls are located behind the drawer.
(See Fig.2 for Manual Control lay out)
Switch ‘A’:- Controls the electricity supply to the re.
Note: This switch must be in the ‘ON’ ( I ) position for the re to operate
Switch ‘B’:- Controls the function of the re.
Press once to turn on ame effect. This will be indicated by one beep.
Although the main lights operate immediately it will take a further 30 seconds before the ame effect starts.
Press to put re in to standby mode.
This will be indicated by one beep.
Control Knob ‘C’:- Controls the intensity of the ame effect.
Turning the control knob up increases the ame effect, turning the control knob down will decrease the ame
effect.
When the water tank is empty the main lamps go out. See instructions under ‘Maintenance’, ‘Filling the water tank’.
When this procedure is complete, the main lamps will illuminate but it will take 30 seconds before the ames return.
Remote Control Operation
On the control panel, Switch A (see Fig.2) must be in the ‘ON’ ( I ) position in order for the remote control to operate.
There are 2 buttons on the remote control. (See Fig.7)
To operate correctly the remote must be pointed towards the front fuel effect.
The remote control functions are as follows:
Press once to turn on Flame effect only.
This will be indicated by one beep.
Standby
This will be indicated by one beep.
Battery Information.
1. Unclip the battery cover on the back of the remote control. (See Fig.7)
2. Install AAA batteries into the remote control.
3. Replace the battery cover.
Discard leaky batteries.
Dispose of batteries in the proper manner according to provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all the batteries are
not replaced at the same time, if disposed of in a re, or if an attempt is made to charge a battery not intended to be
recharged.
Tips for using your appliance.
1. Only pull out the drawer when its time to re ll the water tank or change a lamp, otherwise it may lead to excess water
in the sump and reduced ame effect. If this happens empty the water from the sump as instructed under ‘Maintenance’.
2. With the ame setting on minimum the unit will use approximately 40ml of water per hour and will last 3 times as long
than when it is at maximum ame setting.
3. Do not tilt or move the re while there is water in the tank or sump.
Installation Instruction
17
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimplex Cassette L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Cassette L in the language / languages: English, German, Dutch, Danish, French, Norwegian as an attachment in your email.

The manual is 5,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info