Manual Dimplex Bellini (page 4 of 26) (English, German, Dutch, French, Italian, Polish, Swedish, Spanish, Norwegian)

706500

Zoom out

Zoom in

1/26

Electrical Connection

WARNING – THIS APPLIANCE MUST BE EARTHED

This heater must be used on an AC ~ supply only and the voltage

marked on the heater must correspond to the supply voltage.

Before switching on, please read the safety warnings and

operating instructions.

Controls - see Fig. 2

Three switches provide a choice of heat settings. The appliance

is in standby mode when the mains lead is plugged in. This is

indicated by the red neon behind the ame effect screen. The

two selector switches are in the ON position when the side with

the markings on (i.e. I, or II) are pushed in.

Push button switch 1 Controls the electricity supply to

the heater and ame effect.

If both selector switches 2 and 3 are in the OFF position, the

product works on ame effect only.

Selector switch 2 (I) Provides 750W heat output

Selector switch 3 (II) Provides 1500W output with switch

2 also pressed.

Thermostat (T) - see Fig. 3

In order to maintain a certain room temperature, set the controller

to ‘max.’. Operate the appliance at full power until the required

room temperature is reached. Set back the thermostatic controller

until the appliance switches off with an audible “click”. This

temperature will be kept almost constant by the thermostatic

control switching on and off automatically.Please note that the

appliance can only be switched on when the thermostat setting

is higher then the room temperature.

Remote control - see Fig. 4

The maximum range of use is ~ 5metres.

Warning: It takes time for the receiver to respond to the

transmitter.

Do not press the buttons more than once within two seconds

for correct operation.

Battery Information - see Fig. 4

1. To activate the remote control remove the battery isolation

strip, which is used to ensure your remote control reaches you

fully charged.

2. To replace the remote control battery, turn over the remote

control, and follow the diagram embossed on the remote control

3. Only use CR2025 or CR2032 size of batteries.

Tipping Restraint - see Fig. 1

WARNING: FALLING OR TIPPING APPLIANCES CAN

CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE

ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON

THIS PRODUCT.

WARNING: THE APPLIANCE IS PROVIDED WITH A TIPPING

RESTRAINT, THIS RESTRAINT IS NOT A SUBSTITUTE FOR

PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE

PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW

CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH

THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN

INJURY AND DAMAGE.

This product is provided with a ‘Tipping Restraint Kit’ as

shown in Fig 1, to prevent the product accidentally tipping

over. Fitting Instructions are supplied with this kit please

follow these instructions carefully.

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance

automatically in the event of a fault! Switch off the appliance or

disconnect the mains plug from the socket.

Remove any obstructions which may have caused the

overheating. After a short cooling down phase, the appliance

is ready for use again! If the fault should occur again, see your

local dealer!

WARNING: In order to avoid a hazard due to inadvertent

resetting of the thermal cut-out, this appliance must not be

supplied through an external switching device, such as a timer,

or connected to a circuit that is regularly switched on and off by

the utility.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

Light Emitting Diode

This re is tted with LED (Light Emitting Diode) lamps. These

LED lamps are maintenance-free and should not require

replacing during the life of the product.

Cleaning

WARNING – ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use abrasive

cleaners. The glass viewing screen should be cleaned carefully

with a soft cloth.

DO NOT use proprietary glass cleaners.

To remove any accumulation of dust or uff the soft brush

attachment of a vacuum cleaner should occasionally be used

to clean the outlet grille of the fan heater.

It is possible to clean the inner glass and logset by removing

the outer glass panel. To remove the outer glass, remove the

4 screws holding the grille in position, (see Fig.5), remove the

grille and lift clear the outer glass.

Ret the outer glass in reverse of above.

WARNING: do not operate the product without the grille and outer

glass in position as this may effect the operation of the heater.

Recycling

For electrical products sold within the European

Community. At the end of the electrical products

useful life it should not be disposed of with

household waste. Please recycle where facilities

exist. Check with your Local Authority or retailer

for recycling advice in your country.

After Sales Service

Should you require after sales service or should you need to

purchase any spares, please contact the retailer from whom

the appliance was purchased or contact the service number

relevant to your country on the warranty card.

Please do not return a faulty product to us in the rst instance

as this may result in loss or damage and delay in providing

you with a satisfactory service. Please retain your receipt as

proof of purchase.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dimplex Bellini in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 0,9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dimplex Bellini Manual

Product: