534680
49
Zoom out
Zoom in
Previous page
1/68
Next page
Dimension BST 768 / SST 768 User Guide
Maintenance 49
Tip Cleaning Assembly (Brush/Flicker Assembly)
(Refer to Figure 16 on page 50).
NOTE
The flicker should be replaced after 500 hours. It is only
necessary to replace the brush after 2000 hours.
1. Completely power down Dimension. See "Powering Off
Dimension" on page 21.
2. Remove the purge container. See “Dimension Front View” on
page 11.
3. Remove the old flicker. - loosen the flicker attachment (rear)
screws and pull up on the flicker.
4. Insert the new flicker and tighten the rear screws while gently
pushing down on the flicker.
NOTE
The bottom of the material tip must hit in the top 75% of the
flicker.
5. Remove the old tip cleaning brush by loosening the two
mounting screws and pulling up on the brush.
6. Install the new tip cleaning brush, but do not tighten the
mounting screws.
7. With a glove on your hand, move the head so that the tips are
above the tip cleaning brush.
8. Adjust the tip cleaning assembly until the brush lightly touches
the bottom of the Model Tip Shroud. Tighten the brush
mounting screws to 12 in-lbs (1.356 Nm) of torque.
NOTE
Ideally, the top of the brush and the top of the flicker should be
the same height. Brush height, however is more important to tip
maintenance than the flicker height.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info