534680
41
Zoom out
Zoom in
Previous page
1/68
Next page
Dimension BST 768 / SST 768 User Guide
Operation 41
Building a Part from Your File
After CatalystEX sends the CMB file to the printer, the panel
displays Ready to Build along with your file’s name.
Build a part:
Press Start Model. The system will warm up to correct build
temperatures. After warm-up, the panel displays Finding Home,
(the extrusion head is currently finding the top of the modeling base
on which the part is to be built). After finding its starting point,
Dimension begins building the part.
Read the display panel while building:
The top two lines of the display panel show printer-status
messages (see Figure 15). The bottom line of the panel shows the
material amounts remaining in the cartridges.
Figure 15: Display panel during build
Chamber Lights
When a part starts to build, the chamber lights are automatically
ON. You can toggle lights ON or OFF through the Display Panel.
You can also turn the light on continuously. Go to the Idle or
Ready to Build mode. Press Maintenance and then press
Next until Setup Maintenance is displayed. Press Lights
Always. The light will remain ON until the system is powered OFF.
Printer Status
Model File Name
Model Material
Remaining
Support Material
Remaining
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info