534680
38
Zoom out
Zoom in
Previous page
1/68
Next page
38 Operation
Dimension BST 768 / SST 768 User Guide
B. The panel then prompts with, Replace support?
Press Yes. to unload the Support Material.
The panel displays Replacing support,
Press No if you do not wish to unload the support
material.
C. After you have made the above choices, the panel displays
Unloading for approximately 60 to 75 seconds (the
selected materials will be unloaded from the extrusion
head).
D. When unloading is complete, the panel will prompt you to
remove a cartridge based upon your choices - i.e.,
Replace Both Cartridges, Replace Model
(Top) Cartridge, or Replace Support (Bottom)
Cartridge.
2. Remove the material cartridge(s) by first pushing it forward
gently, and then pulling it out of the slot.
When you remove a cartridge there will be approximately
180 cm (6 feet) of filament that will need to be pulled from
the system. (This is normal. Material is only retracted from
the extrusion head during ‘unloading’.)
3. To store a partially used cartridge, place a small flag of tape on
the filament near the cartridge. Cut off and discard the
remaining material. The tape flag ensures the filament does
not retract into the cartridge.
CAUTION
Do NOT try to rewind the filament that
remains in the system. This will cause
material to cross-wind in the cartridge
causing cartridge failure.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info