534682
64
Zoom out
Zoom in
Previous page
1/68
Next page
64 Troubleshooting
Dimension BST 1200 / SST 1200 User Guide
4. Remove excess material found around the head area.
NOTE
Filament feed to the tip can sometimes jam causing a build-
up of material under the head cover.
A. Clean out as much of the material as possible using needle
nose pliers, a probe, or equivalent tool.
B. To facilitate access to areas that may need to be cleaned,
move the material idler wheels out of the way (there is one
idler wheel for support material and one for model material
- Figure 27 illustrates the model side):
Figure 27: Create Access Space for Cleaning - Model Tip Side
Repeat for Support Tip Side
CAUTION
The end of the extrusion tip where the
material enters is called the Liquefier
Tube. Liquefier Tubes are fragile. Use
care when working in this area so as to
avoid damage to the tubes.
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension BST 1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension BST 1200 in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info